User manual SONY ECM-HW1

[. . . ] If the front (receiving unit) of the receiver does not face the microphone (usually the camcorder's lens side, which faces the subject), reception will be poor. To reduce fire or shock hazard, do not expose the unit to rain or moisture. This product can be used in the country or region where purchased (if outside Europe). for customers in Europe , please refer to the other operating instructions. [. . . ] ⷠWhen used with a camcorder compatible with 5. 1ch CENTER mode, this wireless microphone will provide center channel sound, delivering clear, natural sound. Using the arm band Attach the microphone with the clip to the arm band and secure it with the elastic cord to prevent it from falling, and then wear the arm band on your arm. Immediately after the switches are set, the communication lamps on both devices start blinking blue slowly, during which the devices are trying to detect, connect to, and authenticate each other. When connection is established, ready for clear sound recording, the communication lamp on each device lights up blue. Immediately after the switches are set, the communication lamps on both devices start blinking blue slowly, during which the devices are trying to detect, connect to, and authenticate each other. When connection is established, ready for clear sound recording, the communication lamp on each device lights up blue. Bluetooth wireless technology allows communication between various Bluetooth devices without using cables. Devices that can use this technology include PCs, computer peripheral devices, PDAs and mobile phones. Notes Bluetooth wireless communication may be affected under the following conditions. ­ When there are obstacles such as people, metallic objects, walls, or reflective surfaces between the receiver and the microphone. ­ When used in a location where a wireless LAN system environment exists, near the place where multiple Bluetooth devices are operated, near a working microwave oven, or where electromagnetic wave is emanated. Do not let any liquid or foreign objects get inside the casing. Do not use this wireless microphone in a medical institution such as a hospital, near a medical electrical device, in an aircraft, or if radio interference with another device(s) occurs. RF energy emitted from this wireless microphone may interfere with other devices, resulting in an accident. Do not drop, knock or subject it to excessive shock. ⷠKeep the wireless microphone away from high temperature and humidity. ⷠIf the microphone is placed near speakers, a howling effect (acoustic feedback) may occur. If this happens, place the microphone farther away from the speakers, or lower the volume of speakers. ⷠIf you touch the microphone during recording, noise will be recorded. Be careful not to touch the microphone with your hands, etc. When used at low temperature, the battery performance drops compared to use at normal temperature (25 ºC (77 ºF)) and operating time becomes shorter. [. . . ] 2Front (receiving unit) 3Lock knob 4Shoe connector (terminal) 5Communication lamp The lamp lights, blinks or goes out according to the status of the devices and communication as follows. Status Immediately after turning on the receiver and microphone Connection established and sound can be recorded clearly Turning off the receiver or the camcorder Turning off the microphone Interrupted audio due to bad communication conditions 6Power/Mode switch Goes out Blinks blue slowly Blinks blue quickly Blinks blue slowly Goes out Lights up 7Communication lamp (see the table in 5) 8Microphone (sound pickup unit) 9Battery warning lamp The red warning lamp blinks about once a second when the remaining battery charge of the microphone becomes low. 0Power switch To prevent battery drain, turn off the Power switch when not in use. QaBattery compartment lid qsClip Use this to attach the microphone to clothes or the supplied arm band. [. . . ]