User manual SONY EXCD-406

[. . . ] -- Consult the dealer or an experienced radio/ TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. This unit lets you enjoy a variety of features. You can use an optional rotary remote (RM-X2S) (EXCD-406 only). [. . . ] Press the desired number button ((1) to (6)) for two seconds until "MEM" appears. Each source can store the bass and treble level independently. Note If you try to store another station on the same number button, the previously stored station will be erased. Press the number button ((1) to (6)) momentarily where the desired station is stored. Press either side of (SEEK/AMS) momentarily to search for the station (automatic tuning). Scanning stops when the unit receives a station. Press either side of (SEEK/AMS) repeatedly until the desired station is received. Note If the automatic tuning stops too frequently, press (SENS) momentarily until "LCL" appears in the display (local seek mode). Only the stations with relatively strong signals will be tuned in. Tip If you know the frequency of the station you want to listen to, press and hold either side of (SEEK/AMS) for two seconds until the desired frequency appears (manual tuning). Adjust within three seconds after selecting the item. (After three seconds, the buttons work as volume control buttons. To go back to the normal mode, press again until "MONO" disappears. You can enjoy clear and powerful bass sound. The D-bass function boosts the low frequency signal with a sharper curbe than conventional bass boost. Each time you press (DSPL), the items alternate between the frequency and time. You can hear the bass line moe clearly even if the vocal sound is the same volume. You can emphasize and adjust the bass sound easily with the D-bass control. This effect is similar to the one you get when you use an optional subwoofer system. Moeover, the Digital D-bass* function creates even shaper and more powerful bass sound than Analog D-bass. If your car was parked in direct sunlight resulting in a considerable rise in temperature inside the car, allow the unit to cool off before operating it. ⷠIf no power is being supplied to the unit, check the connections first. [. . . ] Before going through the checklist below, check the connection and operating procedures. Indications do not appear in the Remove the front panel and clean the connectors. An optional power amplifier is connected and you are not using the built-in amplifier. The unit is installed at an angle of more than 20°. [. . . ]