User manual SONY EXCD206

[. . . ] The use of optical instruments with this product will increase eye hazard. Before operating the unit for the first time or after replacing the car battery, you must reset the unit. Align part A of the front panel to part B of the unit as illustrated, and push until it clicks. When you cannect the power supply cord to the unit or reset the unit, wait for about 10 seconds before you insert a disc. [. . . ] Note If "_ _ " or " _ _" appears in the display, you have reached the beginning or the end of the disc and you cannot go any further. The first 10 seconds of all the tracks are played. When you find the desired track, press again. Each time you press (MODE), the mode change as follows: Each time you press (MODE), the mode changes as follows: When the currently played track is over, it will be played again from the beginning. The unit will be starts scanning the selected band and memories the tuned stations on the number button (1) through (6) automatically. The unit does not store stations with weak signals. If only a few stations are received, some number buttons remain empty. ⷠWhen a number is indicated in the display, the unit starts storing stations from the one currently displayed. ⷠIf a CD is not in the unit, only the tuner band appears even if you press (SOURCE). Playing tracks in random order -- Shuffle Play You can store up to 6 stations on each band (18 for FMI, FMII and FMIII, 6 for AM) in the order of your choice. Press either side of (SEEK/AMS) to tune in the station that you want to store on the number button. If everything is in order, check the fuse. ⷠIf no sound comes from the speakers of a two-speaker system, set the fader control to the center position. ⷠIf your car is equipped with a power antenna, note that it will extend automatically while the unit is operating. If you have any questions or problems concerning your unit that are not covered in this manual, please consult your nearest Sony dealer. Turn the D-BASS dial to adjust the bass level (1, 2 or 3). A dirty or defective disc may cause sound dropouts while playing. To enjoy optimum sound, handle the disc as follows. To keep the disc clean, do not touch the surface. To obtain the beep tone again, press these buttons again. Note If you connect an optional power amplifier and do not use the built-in amplifier, the beep tone will be disabled. Only for cars with an accessory position on the ignition key switch To turn the Power Select Function ON Press (OFF) while pressing (SEL). [. . . ] cD player section System Signal-to-noise ratio Frequency response Wow and flutter Laser Diode Properties Material Wavelength Emission Duration Laser output power Compact disc digital audio system 90 dB 10 ­ 20, 000 Hz Below measurable limit GaAlAs 780 nm Continuous Less than 44. * This output is the value measured at a distance of 200 mm from the objective lens surface on the Optical Pick-up Block. Design and specifications are subject to change without notice. The following checklist will help you remedy the problems that you may encounter with your unit. [. . . ]