User manual SONY EXCD2RF

[. . . ] Output: 20 W × 4 ch) enables you to enjoy 4-speaker systems. Line outputs for connecting an optional power amplifier. Quick recovery mechanism for preventing sound skipping. Convenient functions such as the Intro Scan Function for locating a desired track, the Repeat Play Function for playing a track repeatedly, and the Shuffle Play Function for playing tracks in random order. [. . . ] Be sure not to drop the panel after detaching it from the unit. Apply the right side of the front panel to the unit by attaching part A of the front panel to part B of the unit as illustrated, then swing the left side into the unit and push it until clicks. Make sure that the front panel is the right way up when attaching it to the unit as it cannot be attached upside down. Do not press the front panel hard against the unit when attaching it to the unit. It can easily be attached by pressing it lightly against the unit. When you carry the front panel with you, put it in the supplied front panel case. Do not press hard or give excessive pressure to the display window of the front panel. Before removing the front panel, be sure to turn the power off. However, if you press the RELEASE button to detach the panel while the unit is still turned on, the power will automatically turn off in order to protect the speakers from being damaged. Do not expose the front panel to direct sunlight, heat sources such as hot air ducts or leave it in a humid place. Of a car parked in direct sunlight where there may be a considerable rise in temperature inside the car. Only the stations with relatively strong signals will be tuned in. Release the button when the desired station is received. Tune in the station which you wish to store on a preset number button. Press and hold the desired preset number button ( 1 to 6 ) for about two seconds until you hear a beep tone. When tuning in during driving, use automatic tuning. The number of the pressed preset number button appears in the display window. Up to 6 stations on each band (FM I, FM II, FM III and AM) can be stored on the preset number buttons in the order of your choice. Therefore, 18 stations can be memorized on FM. If you try to store another station on the same preset number button, the previously stored station will be erased. Stations with the clearest reception are automatically searched and memorized on each band (FM I, FM II, FM III, and AM). Up to 6 stations on each band can be stored on the preset number buttons 1 to 6 in the order of band frequency. [. . . ] * This output is the value measured at a distance of 200 mm from the objective lens surface on the Optical Pickup Block. Design and specifications are subject to change without notice. The following checklist will assist in the correction of most problems which you may encounter with your unit. Before going through the checklist below, refer to the connection and operating procedures. [. . . ]