User manual SONY EXR-10

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. [. . . ] Make sure that the front panel is the right way up when attaching it to the unit as it cannot be attached upside down. Playing tracks repeatedly -- Repeat play When the currently played track is over, it will be played again from the beginning. Press (SEEK/AMS) to search for the station which you wish to store on the preset number button. Press the desired preset number button ((1) to (6)) for two seconds until a beep sounds. This function selects from the currently received band the stations with the strongest signals and memorizes them in order of their frequency. When tuning in during driving, use the automatic tuning and the memory preset search function instead of the manual tuning. The number of the pressed preset number button appears on the display window. Press the preset number button ((1) to (6)) momentarily on which the desired station is stored. Each time you press (FM) or (AM), the band changes as follows: Tip Press either side of (PRESET/DISC) momentarily to receive in order the stations stored in the memory (Preset Search Function). Press (SENS/BTM) momentarily until "MONO" lights up on the display. The sound will improve, but it will become monaural. When you find the desired track, press again . To play all the tracks in the current changer in a random order Press (3) repeatedly during CD playback until "SHUF 2" is displayed. Each time you press (3) the display changes as follows: $ SHUF 1 (Disc shuffle) $ SHUF 2 (Changer shuffle) $ Cancel (Normal CD playback mode) -- Repeat play To repeat a track Press (2) repeatedly during CD playback until "REP 1" is displayed. If you press (1) during shuffle play, the first 10 seconds of all tracks will be played in random order. Press (2) repeatedly during CD playback until "REP 2" is displayed. Press (2) repeatedly during CD playback until "REP 3" is displayed. Each time you press (2) the display changes as follows: REP 1 (Track repeat) REP 2 (Disc repeat) Playing tracks in random order -- Shuffle play To play the tracks on the current disc in a random order Press (3) repeatedly during CD playback until "SHUF 1" is displayed. If your car was parked in direct sunlight resulting in a considerable rise in temperature inside the car, allow the unit to cool off before switching on. If no power is being supplied to the unit, check the connections first. If everything is in order, check the fuse. If no sound comes from the speakers of a 2-speaker system, set the fader control to the center position. [. . . ] Cassettes longer than 90 minutes The use of cassettes longer than 90 minutes is not recommended except for long continuous play. The tapes used for these cassettes are very thin and tend to be stretched easily. Frequent playing and stopping of these tapes may cause them to be pulled into the cassette deck mechanism. The unit may not function properly if the connectors between the unit and the front panel are not clean. [. . . ]