User manual SONY EXR-25

[. . . ] All warnings and cautions in the Operating Instructions and on the unit should be strictly followed, as well as the safety suggestions below. "CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. " Warning To prevent electric shock or injury, these safety instructions should be followed in the installation, use and servicing the unit. Installation Attachments - Do not use attachments not recommended by the unit manufacturer as they may result in the risk of fire, electric shock or injury to persons. Water and Moisture - Do not use this unit near water - for example, near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool, and the like. Heat - Do not use this unit near sources of heat, including heating vents, stoves, or other appliances that generate heat. [. . . ] The selected track number lights up on the display. ·Do not place more than one disc. ·Do not tilt the unit with a disc loaded. ·The unit may not play CD-R/RW discs recorded on personal computers or certain kinds of CD-R/RW recorders. ·Do not attach adhesive label to either side of CD-R/RW discs, as doing so may cause malfunction. ·Do not load an unrecorded CD-R/RW disc. ·Do not use irregular-shaped CDs. En 3 Repeat step 2 to program other tracks. The total number of selected tracks and total playing time will be displayed. 4 Press E to start play. The track number for the current track flashes on the display. ·During programmed play, you cannot select a track with the numbered buttons. "CAN'T USE " is displayed when you try to select a track . ·If the total playing time of the program exceeds 99 minutes and 59 seconds, or if a track with a track number exceeding 30 is programmed, the playing time is displayed as "- -:- - ". ·You cannot program more than 30 tracks. "FULL " is displayed. 9 RADIO OPERATIONS Tuning in preset stations TUNER MODE TUNER/ AUX/BAND POWER 0­10, +10 s SET SHIFT PRESET +, TUNER/BAND f, g 1 Select the band. Slack tape may jam in the mechanism. En REC/ REC PAUSE SYNCHRO REC s s c f, g zPUSH EJECT SHIFT Playback Use only type I (normal) tapes. 1 Press zPUSH EJECT to open the cassette holder. 2 Insert the tape. Insert with the exposed side down and the side to be played facing out from the unit, and press zPUSH EJECT to close the cassette holder. To stop playback Press s. To reset the tape counter Press s in stop mode, and the tape counter on the display is reset to "0000 ". Opening and closing the cassette holder will also reset the tape counter. To eject the tape Press zPUSH EJECT after the deck stops completely. 3 Press c to start play. 12 TAPE RECORDING Basic recording Use only type I (normal) tapes. 1 Press zPUSH EJECT to open the cassette holder. 2 Insert the recording tape. Insert with the exposed side down, and the side to be recorded on facing out from the unit. Press zPUSH EJECT to close the cassette holder. To start CD recording more easily Insert the tape to be recorded, load the disc, and press SYNCHRO REC. Regardless of the function currently selected, CD play and tape recording start simultaneously. ·In CD stop mode, tape recording starts from the beginning of the disc (all tracks recording). When CD playback stops, tape recording stops simultaneously. [. . . ] After playing a CD, store it in its case. Care of tapes Store tapes in their cases after use. Do not leave tapes near magnets, motors, television sets, or any source of magnetism. Do not expose tapes to direct sunlight, or leave them in a car parked in direct sunlight. Troubleshooting If your unit fails to perform properly, check the following guide and the relevant sections of the Operating Instructions. There is no sound ·Are the speakers and AC power cord connected properly? [. . . ]