User manual SONY FA-EC1AM

[. . . ] With continued use, the low-battery indicator will disappear and battery performance will improve. This could trigger the battery's internal thermal safety switch shutting off the circuit and terminating flash charging. Wait until the batteries become cold before using this unit and the flash again. The chart below shows performance data when using new batteries in our standard test environment. [. . . ] Therefore it is advisable to have a spare set of batteries. Remove the batteries when storing this unit for an extended period of time. This unit is designed for use from 0 °C to 40 °C (32 °F to 104 °F). If it comes in contact with water, wipe it dry with a clean cloth and take it to the nearest Sony dealer immediately. Take it to the nearest Sony dealer immediately for repair. When dirty, this unit may be cleaned with a clean, dry cloth. Do not allow this unit to come in contact with alcohol or other chemicals. Never leave this unit where it may be subjected to extreme temperatures, such as the glove compartment of a car. 1 2 3 4 5 Attaching screw socket cover Charge lamp Battery-chamber door Lock-release button Connecting cord The following battery types are compatible with this unit. 1 Press the lock - release button in the direction of the arrow , 2 Insert the batteries into the chamber according to the polarity (+/-) 3 Close the battery-chamber door by pressing it against this unit And sliding it in the direction of the arrow until it clicks into place (Illustration ). When using your photographic equipment, basic safety precautions should always be followed, including the following: Read and understand all instructions before using. Close supervision is necessary when any appliance is used by or near children. Do not leave appliance unattended while in use. Care must be taken as burns can occur from touching hot parts. , This unit can be attached to the camera body s tripod socket with the supplied attachment screw (Illustration ). With full flash fire, the flash ready lamp should come on within 30 sec. If not, exchange the batteries both in the flash and this unit. The low-battery indicator shows low battery when recycle time is short but battery capacity is low. Do not operate appliance with a damaged cord or if the appliance has been dropped or damaged- until it has been examined by a qualified serviceman. let appliance cool completely before putting away. [. . . ] let appliance cool completely before putting away. Loop cord loosely around appliance when storing. To reduce the risk of electric shock, do not immerse this appliance in water or other liquids. To reduce the risk of electric shock, do not disassemble this appliance, but take it to a qualified serviceman when service or repair work is required. [. . . ]