User manual SONY FWD-40LX2F/SI

[. . . ] To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. On transportation When you carry the display unit, hold the unit itself, not the speakers. If you fail to do so, the speakers may come out of the unit and the unit may fall. This can cause injury. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] · You cannot input the signal indicated with * to DVI IN. · The signals indicated with ** cannot automatically be distinguished from one another. Every time you execute "Auto Adjust" of "Adjust Screen" in the "SCREEN CONTROL" menu, one of the settings for those signals will be applied consequently. Select the appropriate setting. Actual on-screen display of the unit's status On-screen display 640×480 / 60 (e. g. ) 480 / 60i (e. g. ) Significance The selected input signal is computer RGB. The selected input signal is component video. The selected input signal is NTSC. PAL NTSC SECAM NTSC4. 43 PAL60 PAL-M PAL-N 575/50I 480/60I 1080/48I 1080/50I 576/50P 480/60P 1080/60I 720/60P 720/50P NTSC (e. g. ) Not Supported Signal The input signal is out of the capture range. No Sync INPUT1 DVI INPUT2 RGB INPUT2 Component Option1/2 Video There is no input signal. The signal mode of INPUT1 is set to digital RGB. The signal mode of INPUT2 is set to analog RGB. The signal mode of INPUT2 is set to component video. The signal mode of OPTION1 or OPTION2 slot is set to composite video. Adjust the sharpness with M/m/</, within the range of MIN (0) to MAX (20), then press ENTER. M/, : Increases the sharpness of the image. m/<: Decreases the sharpness of the image. Select Set ENTER Exit MENU 2 Noise Reduct. Reduces image graininess and color noise. Select the Dynamic Picture mode with M/m. Off: Disables the Dynamic Picture function. On: Enables the Dynamic Picture function. Press ENTER to return to the Adjust Picture menu. 1 3 Select "Noise Reduct. " with M/m and press ENTER. The following menu appears on the screen. PICTURE/SOUND CONTROL Adjust Picture Contrast: Brightness: Chroma: Phase: Sharpness: Noise Reduct. : Dynamic Picture: Color Temp. : 70 50 25 Off 0 Low 5 Mid Off High Off Neutral Color Temp. You can set color temperature. Either select one from "Cool, " "Neutral, " or "Warm, " or set values for each gain separately. 1 Exit MENU Select Set ENTER Select "Color Temp. " with M/m and press ENTER. Select the color temperature with M/m and press ENTER. Cool: Sets the color temperature to high. Neutral: Sets the color temperature to neutral. [. . . ] For details on the "On/Off Timer" function, see "On/Off Timer Function" on page 38 (GB). Turn off the power, and make sure that the air vents are not blocked, that there is ample space for air to flow around the display, and that the ventilation in the room is working properly. When the internal temperature returns to normal, the display will operate properly again. For details on installation conditions, see "Precautions" on page 5 (GB) and "Caution" on page 13 (GB). [. . . ]