User manual SONY GDM-400PST9

[. . . ] Dangerously high voltages are present inside the set. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Step 5: If necessary, adjust the user controls according to your personal preference. Notice To comply with the limits of FCC Class B and IC Class B for digital device, please attach the supplied video signal cable for HD15 input or SMF-400 (sold separately) for BNC input. 9 pin) adapter (supplied) for current DOS computer which has no compliance of DDC 2AB and its No. The Multiscan 17seII has factory preset modes for the 10 most popular industry standards for true "plug and play" capability. When using a video mode that is not one of the 10 factory preset modes, some fine tuning may be required to optimize the display to your preferences. Simply adjust the monitor according to the preceding adjustment instructions. For less common modes, and modes that evolve in the future, the Digital Multiscan Technology of the Multiscan 17seII will perform all of the complex adjustments necessary to ensure a high quality picture for any timing in its frequency range. However, due to the wide variety of video boards on the market, it may be necessary for the user to fine tune the vertical/horizontal size and centering. Note: For Windows®4) users, check your video board manual or the utility program which comes with your graphic board and select the highest available refresh rate to maximize monitor performance. See the given pages for further description. U power switch and indicator (page 12) Press to turn the monitor on or off. To release the Lock mode, set it to off (UNLOCK) position. Normally keep this function set to off (UNLOCK) position. When you switch between input sources, the monitor screen is muted for a moment (Mute) then the signal through the selected input is displayed. If the selected input do not receive any video signals, the monitor automatically returns to the other input after Mute and the OPTION OSD appears. to erase the OPTION OSD , press the OPTION button again. The OSD automatically disappears 30 seconds after you release the buttons. If two computers are connected to the monitor (one to each input), when one of the computers is turned on or restarted, or the monitor goes into power saving mode, the monitor may switch to the other input because the signal is temporarily interrupted. Select the input which you use, following the above steps. The control buttons on the front panel except the OPTION button do not work. If you press any button except the u power switch and OPTION button, the mark appears on the screen. The OSD automatically disappears 30 seconds after you release the buttons. [. . . ] This section may help you isolate a problem and as a result, eliminate the need to contact technical support, allowing continued productivity. No picture / If neither the u (power) indicator nor the POWER SAVING indicator is not lit. -- Check that your computer power switch is in the "on" position. -- The monitor will recover when you press any key on the keyboard of the computer. [. . . ]