User manual SONY GDM-F400

[. . . ] The model and serial numbers are located at the rear of the unit. record these numbers in the spaces provided below. Refer to them whenever you call upon your dealer regarding this product. To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] Move the joystick up, down, left, or right to make the adjustment. Press the joystick once to return to the main menu, and twice to return to normal viewing. If no buttons are pressed, the menu closes automatically after about 30 seconds. This setting is stored in memory for the current input signal. Adjusting the size of the picture (SIZE) This setting is stored in memory for the current input signal. Size, and left or right to adjust the horizontal size. It may appear due to interference between the pattern of the picture on the screen and the phosphor pitch pattern of the monitor. Note The picture may become fuzzy when CANCEL MOIRE is set to ON. 3 First move the joystick up or down to select the desired adjustment item. Then move the joystick left or right to make the adjustment. Select H CONVERGENCE vertically shift red or blue shadows V CONVERGENCE TOP V CONVER TOP BOT V CONVER BOT LANDING vertically shift red or blue shadows at the top of the screen vertically shift red or blue shadows at the bottom of the screen select one of the four corners of the screen :top right :top left :bottom left ADJ LANDING ADJUST :bottom right To horizontally shift red or blue shadows Reduce any irregularities in the color of the corner selected in LANDING to a minimum You can manually degauss (demagnetize) the monitor, change the menu position, set the power saving delay time, and lock the controls. This monitor has the following three reset methods. Use the joystick to select the adjustment item you want to reset, and press the RESET button. Adjust the selected item according to the following instructions. Note that the following items are not reset by this method: · The monitor is automatically demagnetized when the power is turned on. To manually degauss the monitor, first move the joystick up or down to select (MANUAL DEGAUSS). If a second degauss cycle is needed, allow a minimum interval of 20 minutes for the best result. Press and hold the reset button for more than two seconds. To change the menu's on-screen position, first move the joystick up or down to select (OSD H POSITION) for horizontal adjustment, or (OSD V POSITION) for vertical adjustment. Then move the joystick to the left or right to shift the on-screen menu. Note The RESET button does not function when To adjust the time it takes to enter the power saving mode, first move the joystick up or down to select ZZ. Then move the joystick to the left or right to select the desired time. [. . . ] The requirements cover a wide range of issues: environment, ergonomics, usability, emission of electrical and magnetic fields, energy consumption and electrical and fire safety. The environmental demands concern restrictions on the presence and use of heavy metals, brominated and chlorinated flame retardants, CFCs (freons) and chlorinated solvents, among other things. The product must be prepared for recycling and the manufacturer is obliged to have an environmental plan which must be adhered to in each country where the company implements its operational policy. The energy requirements include a demand that the computer and/ or display, after a certain period of inactivity, shall reduce its power consumption to a lower level in one or more stages. [. . . ]