User manual SONY GDM-F420

[. . . ] Dangerously high voltages are present inside the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] 0 instruction manual for further details on adjusting the resolution, refresh rate, and number of colors. If you need to change the OSD language, see "Using the LANG (Language) On-screen Display" on page 17. This monitor has two signal input connectors (HD15 and 5BNC) and can be connected to two computers. When the power of both computers is on, select the input signal you want to view as follows. press the INPUT button to select the HD15 or 5BNC input signal. Each time you press the INPUT button, the input signal and corresponding indicator alternate. This monitor has two modes of input signal selection, "AUTO" and "MANUAL. " When "AUTO" is selected If no signal is input from the selected connector, the monitor automatically selects the other connector's signal. When you restart the computer you want to view, or that computer is in power saving mode, the monitor may automatically select the other connector's signal. This is because the monitor switches from the interrupted signal to the constant signal. If this happens, manually select the desired signal using the INPUT button. The "5000K, " "6500K" or "9300K" disappears and the new color settings are memorized for each of the three color modes. To shift red shadows up and blue shadows down To shift red shadows down and blue shadows up Moire is a type of natural interference which produces soft or wavy lines on your screen. It may appear due to interference between the regulated pattern of the picture from the input signal and the phosphor pitch pattern of the CRT. To shift red shadows up and blue shadows down To shift red shadows down and blue shadows up To shift red shadows to the right and blue shadows to the left The picture may become fuzzy when CANCEL MOIRE is set to "ON. To shift red shadows to the left and blue shadows to the right To shift red shadows up and blue shadows down To shift red shadows down and blue shadows up The OPTION OSD allows you to manually degauss the screen and adjust settings such as the OSD position and power saving delay time. It also allows you to lock the controls. You can change the OSD position (for example, when you want to adjust the picture behind the OSD). The monitor screen is automatically degaussed (demagnetized) when the power is turned on. If you need to degauss the screen a second time, wait for at least 20 minutes before repeating the steps above. You can set the delay time before the monitor enters the power saving mode. See page 19 for more information on this monitor's power saving capabilities. [. . . ] If you place equipment which generates a magnetic field, such as a loudspeaker, near the monitor, or you change the direction of the monitor, color may lose uniformity. the degauss function demagnetizes the metal frame of the CRT to obtain a neutral field for uniform color reproduction. If a second degauss cycle is needed, allow a minimum interval of 20 minutes for the best result. If red or blue shadows appear along the edges of images, adjust the convergence (pages 13 ­ 14). [. . . ]