User manual SONY GDM-1936

[. . . ] Dangerously high voltages are present inside the set. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] 9 pin) adapter (not supplied) for current DOS computer which has no compliance of DDC 2AB and its No. Macintosh II series and some older version of PowerBook models may need an adapter with micro switches. The Multiscan 17seII/20seII has factory preset modes for the 10 most popular industry standards for true "plug and play" capability. When using a video mode that is not one of the 10 factory preset modes, some fine tuning may be required to optimize the display to your preferences. Simply adjust the monitor according to the preceding adjustment instructions. For less common modes, and modes that evolve in the future, the Digital Multiscan Technology of the Multiscan 17seII/20seII will perform all of the complex adjustments necessary to ensure a high quality picture for any timing in its frequency range. However, due to the wide variety of video boards on the market, it may be necessary for the user to fine tune the vertical/horizontal size and centering. Note: For Windows®4) users, check your video board manual or the utility program which comes with your graphic board and select the highest available refresh rate to maximize monitor performance. See the given pages for further description. U power switch and indicator (page 12) Press to turn the monitor on or off. The indicator lights up when the monitor is turned on. If two computers are connected to the monitor (one to each input), when one of the computers is turned on or restarted, or the monitor goes into power saving mode, the monitor may switch to the other input because the signal is temporarily interrupted. Select the input which you use, following the above steps. The OSD automatically disappears 30 seconds after you release the buttons. Adjust the moire gradually from 0, and stop the adjustment as near to 0 as possible. This feature allows you to lock the monitor so that all the buttons, except the u power switch and OPTION button, on the front panel cannot be operated (Lock mode). Hence, your settings cannot be modified. With this function, you can ensure that your settings will remain the same even when the control buttons are exposed to others. To release the Lock mode, set it to off (UNLOCK) position. Normally keep this function set to off (UNLOCK) position. The control buttons on the front panel except the OPTION button do not work. If you press any button except the u power switch and OPTION button, the mark appears on the screen. [. . . ] -- Check that your computer power switch is in the "on" position. -- The monitor will recover when you press any key on the keyboard of the computer. -- Check that the video cable is properly connected and all plugs are firmly seated in their socket. -- Check that the 5 BNC's are connected in the right order (from power cord side: RedGreen-Blue-HD-VD). [. . . ]