User manual SONY GDM-20D11

[. . . ] Dangerously high voltages are present inside the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Once the setting is adjusted, it will be stored in memory for the current input signal. To move the picture left To move the picture up . To move the picture down The horizontal and vertical sizes are both reset to the factory settings. The horizontal and vertical centerings are both reset to the factory settings. Once the rotation is adjusted, it will be stored in memory for all input signals received. All other adjustments will be stored in memory for the current input signal. To move the picture sides to the right To move the picture sides to the left Adjust the picture rotation adjust the picture sides adjust the picture side balance adjust the picture width adjust the picture shape balance To move the top of the picture to the right To move the top of the picture to the left Once the setting is adjusted, it will be stored in memory for the current input signal. For example, you can adjust or change the colors of a picture on the screen to match the actual colors of the printed picture. Once the setting is adjusted, it will be stored in memory for all input signals received. The picture zoom adjustment will stop as soon as either the horizontal or vertical size reaches its maximum or minimum value. You can adjust convergence settings to eliminate red or blue shadows that may appear around objects on the screen. This monitor meets the power-saving guidelines set by VESA and Energy Star, as well as the more stringent NUTEK . If the monitor is connected to a computer or video graphics board that is VESA DPMS (Display Power Management Signaling) compliant, the monitor will automatically reduce power consumption in three stages as shown below. You can set the delay time before the monitor enters the power saving mode using the OSD. Set the time according to "Setting the power saving delay time" on page 16. After the delay time has passed, the power saving function automatically puts the monitor into the active-off mode and the u indicator lights up orange. Once the horizontal and vertical sync signals are detected, the monitor automatically resumes its normal operation mode. Horizontal sync signal present absent present absent ­­ When viewing a white background, very thin horizontal lines may be visible on the screen as shown below. These lines are the shadows of the damper wires and are characteristic of CRTs that use aperture grilles. The wires are attached to the aperture grille on the inside of the Trinitron tube and prevent the vibration of the aperture grille. This monitor complies with the DDCTM1, DDC2B, DDC2AB and DDC2B+ Display Data Channel (DDC) standards of VESA. When a DDC1 host system is connected, the monitor synchronizes with the V. [. . . ] the labelling scheme was developed as a joint effort by the TCO (The Swedish Confederation of Professional Employees) , Svenska Naturskyddsforeningen (The Swedish Society for Nature Conservation) and Statens Energimyndighet (The Swedish National Energy Administration). Approval requirements cover a wide range of issues: environment, ergonomics, usability, emission of electric and magnetic fields, energy consumption and electrical and fire safety. The environmental demands impose restrictions on the presence and use of heavy metals, brominated and chlorinated flame retardants, CFCs (freons) and chlorinated solvents, among other things. The product must be prepared for recycling and the manufacturer is obliged to have an environmental policy which must be adhered to in each country where the company implements its operational policy. [. . . ]