User manual SONY GDM-400PS

[. . . ] Dangerously high voltages are present inside the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] It may not work properly if the background color is dark or if the input picture does not fill the screen to the edges (such as an MSDOS prompt). Pictures with an aspect ratio of 5:4 (resolution: 1280 × 1024, 1800 × 1440) are displayed at their actual resolution and do not fill the screen to the edges. The screen may go blank for a few seconds when the ASC button is pressed. You can make numerous adjustments to your monitor using the on-screen menu. See page 11 for more information on using the joystick. Use the joystick to select one of the following menus. You can use this to match the monitor's colors to a printed picture's colors. Move the joystick up, down, left, or right to highlight the desired menu. Brightness and contrast adjustments are made using a separate BRIGHTNESS/CONTRAST menu. These settings are stored in memory for all input signals. Move the joystick up, down, left, or right to make the adjustment. Then move the joystick to the left or right to select the desired time. If you select OFF, the monitor does not enter power saving mode. See page 15 for more information about the monitor's power saving capabilities. To protect adjustment data by locking the controls, first move the joystick up or down to select (CONTROL LOCK). If any other items are selected, the mark appears on the screen. To cancel the control lock Repeat the procedure above and set UNLOCK. When the monitor receives an input signal, it automatically matches the signal to one of the factory preset modes stored in the monitor's memory to provide a high quality picture at the center of the screen. (See page i for a list of the factory preset modes. ) For input signals that do not match one of the factory preset modes, the digital Multiscan technology of this monitor ensures that a clear picture appears on the screen for any timing in the monitor's frequency range (horizontal: 30 ­ 121 kHz, vertical: 48 ­ 160 Hz) . If the picture is adjusted, the adjustment data is stored as a user mode and automatically recalled whenever the same input signal is received. Before contacting technical support, refer to this section. [. . . ] Since all methods of conventional electricity generation have a negative effect on the environment (acidic and climateinfluencing emissions, radioactive waste, etc. Electronics equipment in offices consume an enormous amount of energy since they are often left running continuously. This product meets the requirements for the TCO'95 scheme which provides for international and environmental labelling of personal computers. the labelling scheme was developed as a joint effort by the TCO (The Swedish Confederation of Professional Employees) , Naturskyddsforeningen (The Swedish Society for Nature Conservation) and NUTEK (The National Board for Industrial and Technical Development in Sweden). [. . . ]