User manual SONY GV-D300E

[. . . ] This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] When you have stored an original title The title appears above "CUSTOM TITLE. Title position ("POS") If you select the title size "LG, " you can choose 8 positions. When you select the title size "SM", you can choose 9 positions at all. The titles you superimposed are displayed by only using the DV format video equipment with index titler function. When you are searching the tape using the other video equipment, the portion of the tape you superimpose the title may be detected as an index signal. notes on the cassettes · If you use a cassette tape set to prevent accidental erasure, you cannot superimpose the title. Slide the protect tab so that the red portion is not visible. You can superimpose about 11 to 20 titles in one cassette, if one title consists of about 5 characters. If the tape has too many index signals and photo data, you may not be able to superimpose a title because the memory is full. (3)Turn the control dial to select the title you want to erase, then press the control dial. (4)Make sure the title is the one you want to erase, then press control dial again. "Editing" is to make a new tape from a prerecorded tape by deleting unnecessary scenes and allocating the scenes you want in the desired order. This VCR has the assemble function which enables you to select scenes while playing back a tape. After all the scenes you want have been selected, the VCR automatically assembles them to be recorded on another tape. This preparation is necessary only for the first time you do the assemble editing, as long as you use the same recording VCR. Use a VCR which is controlled by an infrared remote control system. Connect the recording VCR in the same way as "Editing onto another tape" (p. 51) when the VCRs are connected using the DV connecting cable. Set the remote control mode and the button to release the recording pause mode according to the recording VCR. To set the button to release the recording pause mode (5)Turn the control dial to select PAUSE MODE, then press the control dial. (6)Turn the control dial to select the button you press to release recording pause mode on the recording VCR, PAUSE or REC or PB (playback), then press the control dial. * TV/VCR component / Componente de TV/videograbadora Note on remote control mode You cannot do the assemble editing with some VCRs (for recording) if the remote control mode does not correspond to this VCR (for playing). [. . . ] When the CHARGE lamp does not flash again If the CHARGE lamp lights up and goes out after a while, the problem is with the battery pack installed first. Please contact your nearest Sony dealer in connection with the product with the problem. * If you use a battery pack which you have just bought or which has been left unused for a long time, the CHARGE lamp may flash at the first charging. Repeat again to charge with same battery pack. [. . . ]