User manual SONY GV-D800E

[. . . ] Before operating the unit, please read this manual thoroughly, and retain it for future reference. To prevent fire or shock hazard, do not expose the unit to rain or moisture. A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS1362 (i. [. . . ] Step 1: Connecting the other (recording) VCR You can connect either the A/V connecting cable or the i. Dubbing only desired scenes ­ Digital program editing Step 2: Setting the other (recording) VCR for operation - Using the A/V connecting cable To edit using the other (recording) VCR, send the control signal by infrared ray to the remote sensor on the other (recording) VCR. When you connect using the A/V connecting cable, follow the procedures below. (2) Turn the power of the other (recording) VCR on, then set the input selector to LINE. When you connect a digital video camera recorder, set its POWER switch to VCR/VTR. About the IR SETUP code The IR SETUP code is stored in the memory of your VCR. Be sure to set the correct code, depending on the other (recording) VCR. * TV/VCR component/e eepa/eaa Note on the IR SETUP code The Digital program editing does not work if the VCR is not corresponded to IR SETUP codes. (2) Turn the SEL/PUSH EXEC dial to select the mode to cancel recording pause on the other (recording) VCR, then press the dial. The correct button depends on the other (recording) VCR. The buttons to cancel recording pause on the other (recording) VCR Select the buttons when you cancel recording pause on the other (recording) VCR, and start recording. Setting your (playback) VCR and the other (recording) VCR to face each other Locate the infrared rays emitter of your (playback) VCR to face it towards the remote sensor of the other (recording) VCR. set the devices more than 30 cm (12 in. ) apart, and remove any obstacles between the devices. (1) Insert a recordable tape into the other (recording) VCR, then set to recording pause. If the other (recording) VCR starts recording, the setting is correct. When finished, the indicator changes to COMPLETE. If the other (recording) VCR does not operate correctly · Place your (playback) VCR at least 30 cm (12 in. Dubbing only desired scenes ­ Digital program editing Step 2: Setting the other (recording) VCR for operation - Using the i. lINK cable (DV connecting cable) When you connect using the i. (2) Turn the power of the other (recording) VCR on, then set the input selector to DV input. When you connect a digital video camera recorder, set its POWER switch to VCR/VTR. [. . . ] Prevent metallic objects from coming into contact with the metal parts of the plugs or jacks. If this happens, a short may occur and the unit may be damaged. While the unit is in use, particularly during charging, keep it away from AM receivers and video equipment. Do not place the unit in locations that are ­ Extremely hot or cold ­ Dusty or dirty ­ Very humid ­ Vibrating Use only the specified charger or video equipment with the charging function. [. . . ]