User manual SONY GV-D900E

[. . . ] Before operating the unit, please read this manual thoroughly, and retain it for future reference. To prevent fire or shock hazard, do not expose the unit to rain or moisture. A moulded plug complying with BS 1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362, (i. [. . . ] (4) Turn the control dial to select the desired character, then press the control dial. In step 3, turn the control dial to select [ M ] then press control dial. To change the title you have made In step 2, turn the control dial to select the title which you want to change, then press the control dial. Erase characters one after another, then make the new title again. If you use a tape with cassette memory, you can label a cassette. the label can consist of up to 10 characters and is stored in cassette memory. When you insert the labeled cassette and turn the power on, the label appears. (5) Turn the control dial to select the column of the desired character, then press the control dial. (6) Turn the control dial to select the desired character, then press the control dial. In step 5 turn the control dial to select [ M ], then press the control dial. To change the label you have made Insert the cassette to change the label, and operate in the same way to make a new label. If the mark appears in step 4 The cassette memory is full. If you erase the title in the cassette, you can label it. if you have superimposed titles in the cassette When the label is displayed , up to 4 titles also appear. Note on "-----" displayed on the menu The "-----" indicates the number of characters you can select for the label. When the "-----" indicator has fewer than 10 spaces, the cassette memory is full. Note on the cassettes If you use a cassette tape set to prevent accidental erasure, you cannot label it. Slide the protect tab so that the red portion is not visible. "Editing" is to make a new tape from a prerecorded tape by deleting unnecessary scenes and allocating the scenes you want in the desired order. This VCR has the assemble function which enables you to select scenes while playing back a tape. After all the scenes you want have been selected, the VCR automatically assembles them to be recorded on another tape. This preparation is necessary only for the first time you do the assemble editing, as long as you use the same recording VCR. [. . . ] Repeat again to charge with same battery pack. This function displays the VCR's condition with five digits (a combination of a letter and figures) on the LCD screen. If this occurs, check the following code chart. M Remove the cassette and leave the VCR for at least 1 hour. [. . . ]