User manual SONY GV-S50

[. . . ] If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover. If you should lose the fuse cover, please contact your nearest Sony service station. The electromagnetic fields at the specific frequencies may influence the picture and sound of this digital video cassette recorder. [. . . ] Also, when you play back the recorded pictures on other video equipment, the picture may jitter. You can duplicate selected scenes (programmes) for editing onto a tape without operating the other (recording) VCR. Step 1 Connecting the other (recording) VCR (p. Step 2 Setting the other (recording) VCR for operation (p. Step 3 Adjusting the synchronicity of the other (recording) VCR (p. When you dub using the same (recording) VCR again, you can skip steps 2 and 3. When you edit a digital video, the operation signals cannot be sent with LANC. When you confirm the set-up video screen, connect your (playing) VCR to a TV, or a monitor using the super laser link function. Step 1: Connecting the other (recording) VCR You can connect either the A/V connecting cable or the i. Dubbing only desired scenes ­ Digital program editing Step 2: Setting the other (recording) VCR for operation - Using the A/V connecting cable To edit using the other (recording) VCR, send the control signal by infrared ray to the remote sensor on the other (recording) VCR. When you connect using the A/V connecting cable, follow the procedures below. LINK in CONTROL, the above procedure is not necessary. IN and OUT are recorded on the image for five times each to calculate the numerical values for adjusting the synchronicity. the EXECUTING indicator flashes on the LCD screen. When finished, the indicator changes to COMPLETE. (4) Rewind the tape in the other (recording) VCR, then start slow playback. Take a note of the opening numerical value of each IN and the closing numerical value of each OUT. (5) Calculate the average of all the opening numerical values of each IN, and the average of all the closing numerical values of each OUT. If you start recording from the very beginning of the tape, the first few seconds of the tape may not be recorded properly. Be sure to allow about 10 seconds' lead before starting the recording. When you complete step 3, the image to adjust the syncronicity is recorded for about 50 seconds. LINK cable (DV connecting cable) You may not be able to operate the dubbing function correctly, depending on the other VCR. [. . . ] To disconnect the mains lead, pull it out by the plug. Do not operate the unit with a damaged cord or if the unit has been dropped or damaged. Do not bend the mains lead forcibly, or place a heavy object on it. This will damage the cord and may cause fire or electrical shock. [. . . ]