User manual SONY HCD-DX150

[. . . ] In door use only. The following FCC statement applies only to the version of this model manufactured for sale in the USA. Other versions may not comply with FCC technical regulations. WARNING This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] [LEVEL1]: Maximum volume level is set to 20. [OFF]: Off. Note You can select the resolution of JPEG image files output from the HDMI OUT jack. [SD ]: The system outputs standard resolution with a black frame. [HD ]: The system outputs HD resolution with a black frame. [HD]: The system outputs the HD resolution without a black frame. [(1920 × 1080i) HD ]: The system outputs full size HD resolution with a black frame. [(1920 × 1080i) HD]: The system outputs full size HD resolution without a black frame. Note · This function is available only when [CONTROL FOR HDMI] is set to [ON]. x [YCBCR/RGB (HDMI)] You can select the type of HDMI signal output from HDMI OUT jack. [YCBCR]: The system outputs YCBCR signals. [RGB]: The system outputs RGB signals. Note · If the playback picture becomes distorted, set [YCBCR] to [RGB]. · If the HDMI OUT jack is connected to a component with a DVI jack, [RGB] signals will be automatically output even when you select [YCBCR]. · [JPEG RESOLUTION] is effective only when you set [TV TYPE] in [VIDEO SETUP] to [16:9], and you set [HDMI RESOLUTION] in [HDMI SETUP] to other than [720 × 480p] or [720 × 576p]. ] or [(1920 × · You can select [(1920 × 1080i) HD 1080i) HD] only when you set [HDMI RESOLUTION] in [HDMI SETUP] to [1920 × 1080i]. Playback restarts at the resume point only for the current disc in the unit. x [RESET] [YES]: Normally select this. [NONE]: Select this if no center speaker is used. [SURROUND] [YES]: Normally select this. [NONE]: Select this if no surround speaker is used. [SUBWOOFER] [YES] Note You can return the [SET UP] settings other than [PARENTAL CONTROL] to the default settings. For details, see "Returning the [SETUP] settings to the default" (page 97). · When you change the [CONNECTION] setting, the [STANDARD] of [SPEAKER FORMATION] setting remains the same, but the other settings of [SPEAKER FORMATION] return to [STANDARD]. Settings for the speakers [SPEAKER SETUP] To obtain the best possible surround sound, set connection of the speakers and their distance from your listening position. Then use the test tone to adjust the level and the balance of the speakers to the same level. Note x [DISTANCE (FRONT)] When you move the front speakers, center speaker, and subwoofer, be sure to set the parameters of the distance (A) from the listening position to the speakers. You can set the parameters from 0. 00 to 7. 00 meters1) (0 to 23 ft). · You cannot operate [SPEAKER SETUP] when you connect headphones to the unit or surround amplifier. 74US [L/R] 3. 00 m/10 ft2)3)4): Set the surround speaker distance. 1) 0. 00 to 7. 01 meters for North American models. you perform the Quick Setup (page 44), the default settings are changed. item appears when you set [SURROUND] to [YES] in the [CONNECTION] setting. 2)When 3)3. 04 A 4)This Disc Note [L/R] 3. 00 m/10 ft2)3): Set the front speaker distance. [CENTER] 3. 00 m/10 ft2)3)4): Set the center speaker distance. [SUBWOOFER] 3. 00 m/10 ft2)3): Set the subwoofer distance. 1)0. 00 · Depending on the input stream, the [DISTANCE] setting may not be effective. · When the speaker distance setting is not in the recommended range, / ** m is displayed (** being the number). [. . . ] The result is enhanced sound field directionality that approaches the quality of discrete 5. 1-channel sound. The Interlace format is the NTSC standard method for displaying TV images at 30 frames per second. Each frame is scanned twice alternately between the even numbered scanning lines and then odd numbered scanning lines, at 60 times per second. Parental Control A function of the DVD to limit playback of the disc by the age of the users according to the limitation level in each country. The limitation 113US varies from disc to disc; when it is activated, playback is completely prohibited, violent scenes are skipped or replaced with other scenes and so on. Progressive format (sequential scanning) · Super Audio CD layer: A high-density signal layer for Super Audio CD · CD layer1): A layer that is readable by a conventional CD player Single layer disc (a disc with a single Super Audio CD layer) In contrast to the Interlace format, the progressive format can reproduce 50 - 60 frames per second by reproducing all scanning lines (525 lines for the NTSC system). The overall picture quality increases and still images, text and horizontal lines appear sharper. [. . . ]