User manual SONY HCR-LV100AV

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. This system can play the following discs Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. This stereo system is equipped with the Dolby* Btype noise reduction system. * Dolby noise reduction manufactured under license from Dolby Laboratories Licensing Corporation. [. . . ] You can create a program of up to 32 tracks from all the CDs in the order you want them to be played. Turn the jog dial until the desired track appears in the display. Disc number Track number Total playing time First "STEP" and the programmed playing order appear, then the total playing time appears. The last programmed track Total playing time Repeat steps 4 through 6 to program additional tracks. Skip step 4 to select tracks from the same disc. All the tracks play in the order you selected. Press PLAY MODE repeatedly until "PROGRAM, " "ALL DISCS SHUFFLE, " or "1 DISC SHUFFLE" disappears from the display. to Check the program Press CHECK on the remote repeatedly. After the last track, "CHECK END" appears. CHECK on the remote repeatedly until the number of the track to be cleared lights up, then press CLEAR. X once in stop mode or twice while playing. Playing CDs without interruption â­Â­ Non-Stop Play You can play CDs without pausing between tracks. Clear the last selected track Clear a specific track Clear the entire program The program you created remains in the CD player's memory even after it has been played. --" appears instead of the total playing time while programming, this means: ­ you have programmed a track numbered over 20, or ­ the total playing time has exceeded 100 minutes. You can record from CDs, tapes, or the radio. For example, you can record just the desired songs or begin recording from the middle of a tape. When you want to record on the reverse side, press h after pressing z REC in step 3 so the indicator on the h button (for the reverse side) lights up green. â· When you want to reduce the hiss noise in lowlevel, high-frequency signals, press DOLBY NR before step 5 so "DOLBY NR B" appears in the display. Press FUNCTION repeatedly until the source you want to record (e. Deck B stands by for recording, and the indicator on the H button (for the front side) lights up green. Press DIRECTION repeatedly until g appears to record on one side or j (or RELAY) to record on both sides. You can record tracks from all the CDs in the order you want. [. . . ] All the settings you made, such as the preset stations, clock, and timer are cleared. Outputs PHONES (stereo phone jack): accepts headphones of 8 ohms or more VIDEO OUT (phono jack): voltage 250 mV, impedance 1 kilohm MD OUT (phono jacks): voltage 250 mV, impedance 1 kilohm WOOFER OUT (phono jack): voltage 1 V, impedance 1 kilohm FRONT SPEAKER: accepts impedance of 6 to 16 ohms CENTER SPEAKER: accepts impedance of 8 to 16 ohms REAR SPEAKER: accepts impedance of 8 to 16 ohms Recording system 4-track 2-channel stereo Frequency response (DOLBY NR OFF) 40 ­ 13, 000 Hz (±3 dB), using a Sony TYPE I cassette 40 ­ 14, 000 Hz (±3 dB), using a Sony TYPE II cassette Wow and flutter ±0. 6 µW* * This output is the value measured at a distance of 200 mm from the objective lens surface on the Optical Pick-up Block with 7 mm aperture. 780 ­ 790 nm 2 Hz ­ 20 kHz (±0. [. . . ]