User manual SONY HDCU-950

[. . . ] HD CAMERA CONTROL UNIT HDCU-950 SD ENCODER UNIT HKCU-951 HD FRAME RATE CONVERTER UNIT HKCU-953 INSTALLATION AND MAINTENANCE MANUAL 1st Edition (Revised 3) Serial No. WARNING This manual is intended for qualified service personnel only. To reduce the risk of electric shock, fire or injury, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. Refer all servicing to qualified service personnel. ! [. . . ] Life of flexile card wire will be significantly shortened if it is folded. Be very careful not to fold the flexible card wire. One flexible card wire between the AU-281 board (CN2) of the unit and the VA-211 board (CA2) of the RMB750 (when the RM-B750 is installed) . One flexible card wire between the VA-211 board (CN14) and MPU-124 board (CN104) of the RM-B750 Removal 1. Slide the portion "A" in the direction of the arrow to unlock and pull out the flexible card wire. Installation A Connector A Contact surface A Recessed portion A Connector Type A m . Do not insert the flexible card wire sideways. Confirm that there is no stain or dust on the contact surface of the flexible card wire. Slide the portion "A" in the direction of the arrow and securely insert the insulated surface (Blue) of the flexible card wire into the connector in the direction that is shown against the recessed portion of the connector. Return the portion "A" to its original position and lock the connector. Recessed portion Insulated surface (Blue) Type B HDCU-950 IMM 1-31 (E) 1-9. Installing the RM-B750 This section describes the installation procedure when the front panel of the remote control unit RM-B750 is used by being installed to the unit. Removing the Front Panel from the RM-B750 1. Loosen the screw (with drop-safe) of the RM-B750 and open the cover in the direction of the arrow. Screw (with drop-safe) 3. Disconnect the connector (CN104) from the MPU-124 board and the connector (CN2) from the VA-211 board respectively. n Life of flexile card wire will be significantly shortened if it is folded. Be very careful not to fold the flexible card wire. Remove the screw and remove the front panel in the direction of the arrow. MPU-124 board (CN104) Front panel B3 x 5 Flexible card wire VA-211 board Cover CN2 2. Loosen the four screws (with drop-safe) and open the front panel and the rear panel in the direction of the respective arrows. Rear panel Flexible card wire Front panel Screws (with drop-safe) Screws (with drop-safe) 1-32 (E) HDCU-950 IMM 1-9. Installing the RM-B750 Installing the Front Panel to the Unit 5. Turn off the power and disconnect the plug from the outlet. Slide the front panel in the direction of the arrow to extract the pin from the potbellied hole and remove the front panel. Pin Potbellied hole 11. Connect the flexible card wire to the connector (CN2) of the AU-281 board. [. . . ] When the HKCU-951 is not installed, the switch is fixed to SD SDI. "Setting of Switches on Boards _ EN-145 Board". *11 : When S10-1 on the RC-91 board and the HKCU-951 are installed, set the switch with S104 on the EN-145 board. For details, refer to Sections 1-6-6 and 1-6-7. [. . . ]