User manual SONY HDR-PJ380/B

[. . . ]  MPEG Layer-3 audio coding technology and patents licensed from Fraunhofer IIS and Thomson.  Windows Media is either a registered trademark or trademark of Microsoft Corporation in the United States and/or other countries.  This product is protected by certain intellectual property rights of Microsoft Corporation. Use or distribution of such technology outside of this product is prohibited without a license from Microsoft or an authorized Microsoft subsidiary. [. . . ] The number of folders that the system can recognize may be less than actual number of folders, depending on the folder structure. Presetting radio stations 1 Tune in the desired station. 2 Press TUNER MEMORY  to select the tuner memory mode. Preset number Adjusting the sound To Adjust the volume Generate a more dynamic sound Set the sound effect Press VOLUME +/ . BASS BOOST . CD, the system automatically turns on 30 seconds before the preset time. If the sound source is set to iPod/iPhone, the system automatically turns on 30 seconds before the preset time.  Make sure the iPod/iPhone is updated with the latest software. If not, update the iPod/iPhone before using with the system.  Adjust the volume. Messages COMPLETE: The preset operation ended normally. CONNECT: The connected iPod/iPhone is executing authentication. DEVICE ERROR: Unpredictable situation (or an unknown device is connected). FULL: You tried to program more than 25 tracks or files (steps). NO DISC: There is no disc in the player, or you have loaded a disc that cannot be played. NO STEP: All of the programmed tracks have been erased. (“TUNED” or “STEREO” flashes on the display. )  Connect the antenna properly.  Find a location and an orientation that provide good reception, and then set up the antenna again.  Keep the antennas away from the power cord to avoid picking up noise.  Turn off nearby electrical equipment. Notes on discs iPod/iPhone section Playing the iPod/iPhone 1 Select the iPod function. Press iPod FUNCTION  on the remote or press FUNCTION  on the unit repeatedly.  rack or file name (“ ”) t  rtist name (“ ”) a  lbum name (“ a ”) Tip The Play Timer setting remains in effect as long as the setting is not canceled manually and clock setting is completed. The system offers the following display modes. Display mode Power Saving mode1) When the system is off The display is turned off to conserve power. The timer and clock continue to operate. The clock is displayed. 5 Program the selected track or file.  to enter the selected track or file. Press “--. --” appears when the total playing time reaches 100 minutes for a CD or when you program MP3 files. 6 Repeat steps 3 through 5 to program additional tracks or files, up to a total of 25 tracks or files. 2 Place the iPod/iPhone. 3 Start playback. Press   on the remote or press   on the unit. Troubleshooting 1 Make sure the power cord is firmly connected. 2 Find your problem in the checklist below, and take the indicated corrective action. If the issue persists, contact your nearest Sony dealer.  Before playing, wipe the disc with a cleaning cloth from the center out to the edge.  Do not clean discs with solvents, such as benzine, thinner, or commercially available cleaners or antistatic spray intended for vinyl LPs. [. . . ] To cancel the Sleep Timer, select “OFF. ”  Move the system away from sources of noise.  Connect the system to a different wall outlet.  Install a noise filter (not supplied) to the power cord. On the speaker system The remote does not function. This speaker system is not magnetically shielded, and the picture on nearby TV sets may become magnetically distorted. In this situation, turn off the TV, wait 15 to 30 minutes, and turn it back on. Play Timer:  Remove any obstacles between the remote and the remote sensor  on the unit, and position the unit away from fluorescent lights. [. . . ]