User manual SONY HDVF20A

[. . . ] 13(J) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14(J) 1 (J) · 2 (J) · · · 3 (J) 1 2 3 ( ) 4 5 6 PEAKING ( ) 7 CONTRAST PEAKING CONTRAST BRIGHT 8 BRIGHT DISPLAY ZEBRA ON OFF MOMENT TALLY HIGH OFF LOW 9 TALLY ASPECT 0 ZEBRA qa DISPLAY/ASPECT 4 (J) 1 7 CONTRAST ( ) 2 8 BRIGHT ( ) 3 ( ) 9 TALLY ( ) 5 4 HIGH OFF LOW 0 ZEBRA ( ) 5 ( 9 ) 9 ON OFF MOMENT qa DISPLAY/ASPECT( / 6 PEAKING ( ) ) DISPLAY: ASPECT: 5 (J) 2 1 4 3 5 VF 1 2 3 4 5 6 (J) PEAKING CONTRAST PEAKING CONTRAST BRIGHT BRIGHT DISPLAY ON OFF MOMENT ZEBRA TALLY HIGH OFF LOW ASPECT 7 (J) 1 2 1 2 2 3 8 (J) 1 2 3 9 (J) 1 (A) ( 3-680-581-01) CRS-3P ( ) 2 3 1 4 10 (J) 1 TALLY TALLY/REC BATT 2 BATT 3 TALLY/REC 4 VTR SAVE VTR SAVE 1 TALLY ( 5 ) 2 BATT ( ) 4 VTR SAVE (VTR ) 5 ( ) 3 TALLY/REC ( / ) · · 11 (J) 12 (J) · · · 1 1 4 2 2 3 4 3 1 2 3 4 13 (J) 14 (J) WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. Dangerously high voltages are present inside the set. Refer servicing to qualified personnel only. For the customers in the USA This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. [. . . ] 2 Stopper Prevents the viewfinder from coming off the camera when it is slid from side to side. 3 Tally indicator (rear) Lights up when the camera receives a tally control signal. This indicator can be covered when not in use. 4 Diopter adjustment ring Allows for optimal foucus adjustment. 5 Tally indicator (front) Lights up when the camera receives a tally control signal. Set the TALLY switch 9 to OFF when not in use. The brightness can also be adjusted with the TALLY switch 9. 6 PEAKING control Turning this control clockwise adjusts the picture sharpness, and makes focusing easier. This control has no effect on the output signals of the camera. 7 CONTRAST control Adjusts the contrast of the screen. This control has no effect on the output signals of the camera. 8 BRIGHT control Adjusts the brightness of the screen. This control has no effect on the output signals of the camera. 9 TALLY switch Controls the tally indicator 5 located on the front of the viewfinder. HIGH: The tally indicator brightness is set to high. LOW: The tally indicator brightness is set to low. 0 ZEBRA (zebra pattern) switch Controls the zebra pattern display on the viewfinder screen as follows: ON: A zebra pattern appears and stays. MOMENT: A zebra pattern appears and stays for about 5 seconds. qa DISPLAY/ASPECT switch Turns the marker indication on and off, and switches between 4:3 and 16:9 aspect ratios for viewfinder screen display. DISPLAY: When the marker indication is enabled with the camera, the marker indication on the viewfinder screen turns on and off every time you push the switch up to this position. ASPECT: Each push of the switch down to this position toggles the mask display on and off. 4(E) Attaching the Viewfinder to a Camera Slide rail 2 Stopper Slide guide Left-right positioning ring 1 4 3 5 Plug VF connector 1 2 3 Loosen the left-right positioning ring on the camera. [. . . ] 1-547-341-12) Lens assembly (farsighted) (Part No. A-8262-537-A) Lens assembly (low magnification) (Part No. A-8262538-A) Lens assembly (standard magnification with special compensation for aberrations) (Part No. A-8267737-A) Performance CRT 2-type monochrome Horizontal resolution 500 TV lines (at center) Signal system Conforming to BTA-S001 and SMPTE274M standards Supported formats Effective scanning lines / Format / Horizontal scanning frequency / Vertical scanning frequency 1080/ 23. 98PsF/ 26. 97kHz/ 47. 95Hz 1080/ 24PsF/ 27kHz/ 48Hz 1080/ 25PsF/ 28. 13kHz/ 50Hz 1080/ 29. 97PsF/ 33. 72kHz/ 59. 94Hz 1080/ 30PsF/ 33. 75kHz/ 60Hz 1080/ 50i/ 28. 13kHz/ 50Hz 1080/ 59. 94i/ 33. 72kHz/ 59. 94Hz 1080/ 60i/ 33. 75kHz/ 60Hz 1035/ 59. 94i/ 33. 72kHz/ 59. 94Hz 1035/ 60i/ 33. 75kHz/ 60Hz Video input 1. 0 Vp-p±6 dB, 75- terminated Indicators REC/TALLY, BATT, VTR SAVE, Related equipment HDC-950 HD Color Video Camera HDW-F900 HD Camcorder Design and specifications are subject to change without notice. 13(E) The material contained in this manual consists of information that is the property of Sony Corporation and is intended solely for use by the purchasers of the equipment described in this manual. [. . . ]