User manual SONY HKSP106 INSTALLAION MANUAL

[. . . ] HD A/V DEMULTIPLEXER BOARD HKSP-106 !WARNING This manual is intended for qualified service personnel only. To reduce the risk of electric shock, fire or injury, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. Refer all servicing to qualified service personnel. ! [. . . ] Displays the number of scanning lines and frequency alternately. When the power is just on or resetting, displays the followings at intervals of 1 second. (Model name) (Software version) (Setting format) HKSP -106 SOFT 1. 00 FMT 108i 5994 108i 5994 . rrepeatedly n When no video signal is input, or when the video signal cannot be detected during the AUTO mode, displays the followings. System Menu (Factory default settings are indicated by a \ mark. ) Item FMT Description Selects the format of an HDTV SDI video input signal. When selecting the input mode by pressing the dial, the number of scanning lines and frequency is displayed alternately. n AUDIO_SG outputs the same signal to AES OUT and Embedded AUDIO. n In the progressive format, 1 field of the burst signal is compatible with 1/2 frame. ASGO Selects the output channel of AUDIO_SG. Surround mode ON \ _ALL: Outputs all 4ch as pair. _OFF: Outputs no audio signal to all channels. Surround mode OFF _ALL: Outputs all 4ch as pair. _OFF: Outputs no audio signal to all channels. SRND Surround mode \ __ON: Turns the surround mode ON. When the surround mode is ON, the specification is changed as follows: - AUDIO SG output select (ASGO) displays _ALL and _OFF, and does not display OUT 1 through OUT 4. If the surround mode is set to ON after one of the following settings (settings for the surround mode OFF only) are used in the surround mode OFF state, the setting will become the factory setting and will not return to the previous setting even if the mode is set to OFF again. Therefore, perform the setting again if necessary. - AUDIO SG output select (ASGO): OUT1, OUT2, OUT3, and OUT4 n The surround mode is basically for a simultaneous processing of the two AUDIO groups and does not support a processing of one group only. Therefore, it is recommended to set the surround mode to OFF when the AUDIO signal comes from only one group. DIAG Self diagnosis mode \ _OFF: Ends the self diagnosis mode. n For details of the diagnosis result, refer to Section "6-2. Self Diagnosis Mode Error Code List". n When the EXIT key is pressed during DIAG, the diagnosis operation is interrupted and ended. The LED display (indicator) during DIAG is controlled normally. The DIAG operation takes about one minute from a start to an end. SOFT Displays the version of CPU software. [. . . ] Input the external audio sync signal to the REF IN B or REF IN A connector on the connector board of the PFV-SP series, and select the DARS from the AREF menu first. Then, selects a REF B or REF A, and uses. (Default setting is B. ) n When the external audio sync signal is selected, and when the selected signal is not detected, the reference is automatically synchronized to the INPUT VIDEO signal. 6. Error/Warning In this unit, the operations below are performed when an error or warning occurs. [. . . ]