User manual SONY HMD-A100-L

[. . . ] Dangerously high voltages are present inside the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] If you connect the monitor to your PC, and then boot your PC for the first time, the setup Wizard may be displayed on the screen. Click on "Next" several times according to the instructions from the Wizard until the Plug & Play Monitor is automatically selected so that you can use this monitor. 0 instruction manual for further details on adjusting the resolution, refresh rate, and number of colors. 2 Connect your computer to the square upstream connector using the supplied USB cable. For customers using Windows If a message appears on your screen, follow the on-screen instructions and select Generic USB Hub as the default setting. Not all computers and /or operating systems support USB configurations. Check your computer's instruction manual to see if you can connect USB devices. The monitor functions as a USB hub as long as the monitor is either "on" or in power saving mode. If you connect a keyboard or mouse to the USB connectors and then boot your computer for the first time, the peripheral devices may not function. first connect the keyboard and mouse directly to the computer and set up the USB compliant devices. Do not lean on the monitor when plugging in the USB cables. These settings are stored in memory for the current input signal. Then move the control button </, to make the adjustment. Select PIN PIN BALANCE To expand or contract the picture sides shift the picture sides to the left or right Then move the control button </, to make the adjustment. These settings are stored in memory for the current input signal. The COLOR settings allow you to adjust the picture's color temperature by changing the color level of the white color field. This setting is stored in memory for all input signals. Then move the control button </, to make the adjustment. Select KEY KEY BALANCE To adjust the picture width at the top of the screen shift the picture to the left or right at the top of the screen Since the default setting is 9300K, the whites will change from a bluish hue to a reddish hue as the temperature is lowered to 6500K and 5000K. This setting is stored in memory for all input signals. Then move the control button m/M button to select R (red), G (green), or B (blue) and move the control button </, to make the adjustment. If you fine tune the color temperature, the new color settings are stored in memory and recalled whenever you select USER. [. . . ] Contact your computer's manufacturer for more information about obtaining a USB supplement disk. If there is a check in the box next to "Disable in this hardware profile, " remove the check. White does not look white USB peripherals do not function A hum is heard right after the power is turned on This is the sound of the auto-degauss cycle. When the power is turned on, the monitor is automatically degaussed for 5 seconds. [. . . ]