User manual SONY HMD-A400/L

[. . . ] Dangerously high voltages are present inside the unit. INFORMATION This product complies with Swedish National Council for Metrology (MPR) standards issued in December 1990 (MPR II) for very low frequency (VLF) and extremely low frequency (ELF). As an ENERGY STAR Partner, Sony Corporation has determined that this product meets the ENERGY STAR guidelines for energy efficiency. Step 1: Connect your monitor to your computer . [. . . ] Not all computers and/or operating systems support USB configurations. Check your computer's instruction manual to see if you can connect USB devices. The monitor functions as a USB hub as long as the monitor is either "on" or in power saving mode. If you connect a keyboard or mouse to the USB connectors and then boot your computer for the first time, the peripheral devices may not function. first connect the keyboard and mouse directly to the computer and set up the USB compliant devices. Do not lean on the monitor when plugging in the USB cables. English, French, German, Italian, Spanish, Russian, and Japanese versions of the on-screen menus are available. You can make numerous adjustments to your monitor using the on-screen menu. Press the center of the control button to display the main MENU on your screen. See page 9 for more information on using the control button. See page 9 for more information on using the control button. This setting is stored in memory for all input signals. Then move the control button </, to make the adjustment. Select KEY KEY BALANCE To adjust the picture width at the top of the screen shift the picture to the left or right at the top of the screen Since the default setting is 9300K, the whites will change from a bluish hue to a reddish hue as the temperature is lowered to 6500K and 5000K. This setting is stored in memory for all input signals. Then move the control button m/M button to select R (red), G (green), or B (blue) and move the control button </, to make the adjustment. If you fine tune the color temperature, the new color settings are stored in memory and recalled whenever you select USER. This setting is stored in memory for the current input signal. Note Adjustment stops when either the horizontal or vertical size reaches its maximum or minimum value. This monitor has the following two reset methods. Reset the settings according to the following instructions. Note that the following items are not reset by this method. [. . . ] *** If the horizontal or vertical sync signal is received by the monitor, the power indicator may alternately blink green and orange. The input signal condition OUT OF SCAN RANGE indicates that the input signal is not supported by the monitor's specifications. Use the self-diagnosis function (page 16) if the following recommendations do not resolve the problem. Symptom No picture If the 1 (power) indicator is not lit If the NO INPUT SIGNAL message appears on the screen, or if the 1 (power) indicator is either orange or alternating between green and orange · Check that the video signal cable is properly connected and all plugs are firmly seated in their sockets (page 6). [. . . ]