User manual SONY HMD-V200/L

[. . . ] Dangerously high voltages are present inside the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] 0 instruction manual for further details on adjusting the resolution, refresh rate, and number of colors. 2 Connect your computer to the square upstream connector using the supplied USB cable. For customers using Windows If a message appears on your screen, follow the on-screen instructions and select Generic USB Hub as the default setting. Adjusting the monitor's resolution and color number Adjust the monitor's resolution and color number by referring to your computer's instruction manual. The color number may vary according to your computer or video board. The color palette setting and the actual number of colors are as follows: · high Color (16 bit) t 65 , 536 colors · True Color (24 bit) t about 16. 77 million colors In true color mode (24 bit), speed may be slower. Not all computers and/or operating systems support USB configurations. Check your computer's instruction manual to see if you can connect USB devices. The monitor functions as a USB hub as long as the monitor is either "on" or in power saving mode. If you connect a keyboard or mouse to the USB connectors and then boot your computer for the first time, the peripheral devices may not function. Then move the control button </, to make the adjustment. Adjusting the horizontal size or centering of the picture (H-SIZE/CENTER) These settings are stored in memory for the current input signal. These settings are stored in memory for the current input signal. Then move the control button </, to make the adjustment. Select PIN PIN BALANCE To expand or contract the picture sides shift the picture sides to the left or right Then move the control button </, to make the adjustment. These settings are stored in memory for the current input signal. The COLOR settings allow you to adjust the picture's color temperature by changing the color level of the white color field. This setting is stored in memory for all input signals. Then move the control button </, to make the adjustment. Select KEY KEY BALANCE To adjust the picture width at the top of the screen shift the picture to the left or right at the top of the screen Since the default setting is 9300K, the whites will change from a bluish hue to a reddish hue as the temperature is lowered to 6500K and 5000K. This setting is stored in memory for all input signals. [. . . ] If there is a check in the box next to "Disable in this hardware profile, " remove the check. White does not look white USB peripherals do not function A hum is heard right after the power is turned on This is the sound of the auto-degauss cycle. When the power is turned on, the monitor is automatically degaussed for 5 seconds. * If a second degauss cycle is needed, allow a minimum interval of 20 minutes for the best result. [. . . ]