User manual SONY HMD-V200/P

[. . . ] Dangerously high voltages are present inside the unit. This device belongs to category B devices as described in EN 55022, unless it is specifically stated that it is a category A device on the specification label. the following applies to devices in category A of EN 55022 (radius of protection up to 30 meters). The user of the device is obliged to take all steps necessary to remove sources of interference to telecommunication or other devices. [. . . ] This indicates that the input signal is not supported by the monitor's specifications. If you replaced an old monitor with this monitor, reconnect the old monitor and adjust the frequency range to the following. Check that the video signal cable is properly connected and all plugs are firmly seated in their sockets. Check that the graphic board is completely seated in the proper bus slot. This monitor has a high luminance mode, so small characters may not appear clearly if the monitor receives signals over 1280 × 1024 resolution. If this occurs, lower the contrast or set the computer to a lower resolution. This indicates that the computer is in power saving mode. This message is displayed only when your computer is in a power saving mode and you press any one of the buttons on the monitor. Try pressing any key on the computer keyboard or moving the Check that all plugs are firmly seated in their sockets. Note that with some input signals and/ or graphics board the periphery of the screen is not fully utilized. Just after turning on the power switch, the size/center may take a while to adjust properly. For input signals that do not match one of the factory preset modes, the digital Multiscan technology of this monitor ensures that a clear picture appears on the screen for any timing in the monitor's frequency range (horizontal: 30 ­ 80 kHz, vertical: 48 ­ 170 Hz). If the picture is adjusted, the adjustment data is stored as a user mode and automatically recalled whenever the same input signal is received. If no signal is received by the monitor from your computer, the monitor will automatically reduce power consumption as shown below. Power mode normal operation active off* power off * Power consumption 1 (power) indicator green orange off When your computer is in active off mode, MONITOR IS IN POWER SAVE MODE appears on the screen if you press any button on the monitor. After a few seconds, the monitor enters the power saving mode again. Design and specifications are subject to change without notice. Warning on power connections · Use the supplied power cord. If you use a different power cord, be sure that it is compatible with your local power supply. For the customers in the UK If you use the monitor in the UK, be sure to use the supplied UK power cable. Be careful not to pinch your fingers at the monitor's stand. Do not remove this monitor's stand. [. . . ] Transportation When you transport this monitor for repair or shipment, use the original carton and packing materials. Hinweis Dieses Gerät erfüllt bezüglich tieffrequenter (very low frequency) und tiefstfrequenter (extremely low frequency) Strahlung die Vorschriften des , , Swedish National Council for Metrology (MPR)" vom Dezember 1990 (MPR II). If the input signal does not match one of the factory preset modes above, the Generalized Timing Formula feature of this monitor will automatically provide an optimal image for the screen as long as the signal is GTF compliant. Below you will find a brief summary of the environmental requirements met by this product. [. . . ]