User manual SONY HMD-V200

[. . . ] Dangerously high voltages are present inside the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Windowsâ and MS-DOS are registered trademarks of Microsoft Corporation in the United States and other countries. Transportation When you transport this monitor for repair or shipment, use the original carton and packing materials. Display Stand Do not remove this monitor's stand. Use of the tilt-swivel This monitor can be adjusted within the angle shown below. To turn the monitor vertically, hold it at the bottom with both hands. Be careful not to pinch your fingers at the back of the monitor when you tilt the monitor up verticaly. Connecting your monitor to your computer When connecting this monitor to a Macintosh computer, use the Macintosh adapter (not supplied) if necessary. You want to adjust and press the center of the joystick. Then move the joystick </, to make adjustments. This monitor complies with the "DDC" Plug & Play standard and automatically detects all the monitor's information. no specific driver needs to be installed to the computer. Try plugging the monitor into a different AC outlet, preferably on a different circuit. Try turning the monitor 90° to the left or right. Check your graphics board manual for the proper monitor setting. Confirm that the graphics mode and the frequency of the input signal are supported by this monitor (see "Preset mode timing table" on page i). Even if the frequency is within the proper range, some graphics board may have a sync pulse that is too narrow for the monitor to sync correctly. When your computer is in active off mode, MONITOR IS IN POWER SAVE MODE appears on the screen if you press any button on the monitor. After a few seconds, the monitor enters the power saving mode again. This monitor has a high luminance mode, so small characters may not appear clearly if the monitor receives signals over 1280 × 1024 resolution. If this occurs, lower the contrast or set the computer to a lower resolution. Check that all plugs are firmly seated in their sockets. Note that with some input signals and/or graphics board the periphery of the screen is not fully utilized. [. . . ] This indicates that the computer is in power saving mode. This message is displayed only when your computer is in a power saving mode and you press any one of the buttons on the monitor. Try pressing any key on the computer keyboard or moving the Check that the graphic board is completely seated in the proper bus slot. To display this monitor's name, serial number, and date of manufacture. [. . . ]