User manual SONY HST-SE581

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. Do not, under any circumstances, place the CD player or any other component on top of the cassette deck receiver HST-SE581. ­ For CD player CDP-C661/CDP-CX571 ­ The mains lead plug of CDP-C661/CDP-CX571 is a 2-pin type designed to be connected only to HST-SE581. [. . . ] Press ) (for front side) or 0 (for reverse side) when the deck is stopped. Press 0 (for front side) or ) (for reverse side) when the deck is stopped. To play a tape recorded with the Dolby NR system, set DOLBY NR to B. The Dolby NR (noise reduction) system eliminates tape hiss noise by boosting low-level signals in the high-frequency range during recording, then lowering them during playback. You can record from CD, or just the songs you want to record from the middle of the tape. See "Recording from a tape" (page 20) to make a copy of the tape. You can use TYPE-I (normal) or TYPE-II (CrO2) tapes. With the side you want to record on facing you Set to a to record on both sides*. You can record a radio program on a tape by calling up the preset station. You can use TYPE-I (normal) or TYPE-II (CrO2) tapes. Press ª twice to start recording from the reverse side. To record with the Dolby NR system, set DOLBY NR to B before you start recording. ⷠTo protect recordings against accidental erasure, break out the record-protect tab (see page 26). Use the number buttons (1 ­ 9, 0/10 (or 0 on the remote) and >10) to select a preset number. If you press buttons on deck A while deck B is recording, the recorded sound will be interrupted. You can copy a tape in deck A to a tape in deck B at normal or high speed. You can use TYPE-I (normal) or TYPE-II (CrO2) tapes. Press ª twice to start recording from the reverse side. To record non-preset stations, tune in the station you want using Manual Tuning or Automatic Tuning feature (see page 14). ⷠIf noise is heard while recording an AM radio program, move the AM antenna to reduce the noise. ⷠTo record with the Dolby NR system, set DOLBY NR to B before you start recording. Press § and insert a recorded tape into deck A and a blank tape into deck B. [. . . ] There is excessive wow or flutter, or the sound drops out. Noise increases or the high frequencies are erased. Make sure the Dolby NR setting matches the setting used when the tape was recorded. ⷠMove the system away from the TV or VCR. [. . . ]