User manual SONY HT-SF2000

[. . . ] 3-210-806-12(1) Home Theatre System Operating Instructions Owner's Record The model and serial numbers are located on the rear of the unit. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. Model No. HT-SF2000 HT-SS2000 ©2007 Sony Corporation WARNING To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. To prevent fire, do not cover the ventilation of the apparatus with newspapers, table-cloths, curtains, etc. [. . . ] 22 ft. ) (0. 1 m (1 ft. ) step) BEHD/HI, BEHD/LO, SIDE/HI, SIDE/LO 0% dim, 40% dim, 70% dim 36GB Menu [Display] A. CAL] (page 29) Parameters [Display] Auto calibration on/offa)e) [AUTO CAL] Calibration loada)d) [CAL LOAD] Settings A. CAL YES, A. CAL NO LOAD NO, LOAD YES Initial setting A. CAL NO LOAD YES a) For b) details, refer to the page in the parentheses. The surround effect is not available for 2CH STEREO and A. F. D. c) When you select this parameter, the "HDMI" indicator flashes in the display. d) When you set "CAL LOAD" in A. CAL menu to "LOAD YES", the setting is displayed as x. xx m (xx'xx") and you can adjust the setting in 0. 01 meter (1 inch) increment. e) After you have select the setting, press to confirm the selection. f) The default setting for models of area code U, UC is "ft. " and for models of other area code is "m". Amplifier Operations 37GB Adjusting the level (LEVEL menu) You can use the LEVEL menu to adjust the balance and level of each speaker. Select "1-LEVEL" in the amplifier menus. For details on adjusting the parameters, see "Navigating through menus" (page 34) and "Overview of the menus" (page 35). LEVEL menu parameters x T. TONE (Test tone) Lets you adjust the speaker levels and balance while listening to the test tone from your listening position. For details, see "7: Adjusting the speaker levels and balance (TEST TONE)" (page 30). Lets you compress the dynamic range of the sound track. This may be useful when you want to watch movies at low volumes late at night. Dynamic range compression is possible with Dolby Digital sources only. OFF The dynamic range is not compressed. STD The dynamic range is compressed as intended by the recording engineer. MAX The dynamic range is compressed dramatically. Tip Dynamic range compressor lets you compress the dynamic range of the soundtrack based on the dynamic range information included in the Dolby Digital signal. STD" is the standard setting, but it only enacts light compression. Therefore, we recommend using the "COMP. This greatly compresses the dynamic range and lets you view movies late at night at low volumes. Unlike analog limiters, the levels are predetermined and provide a very natural compression. x D. [. . . ] If you connect the receiver to an outdoor antenna, ground it against lightning. To prevent a gas explosion, do not connect the ground wire to a gas pipe. Outdoor FM antenna Models of area code CEL, CEK only. Remote control The remote does not function. · For receiver operation, you can only use the DISPLAY button when the TUNER input is selected. · Point the remote at the remote sensor on the receiver. [. . . ]