User manual SONY HT-ST3

[. . . ] 4 Connecting the Bar Speaker and the Subwoofer / Conexión del altavoz de barra y el altavoz potenciador de graves 5 Connection / Conexión Connecting a TV only / Conexión de un TV únicamente OPTICAL OUT (Supplied) (Suministrado) 6 When connecting a TV and other devices / Cuando se conectan un TV y otros dispositivos OUT Blu-ray (ARC) OPTICAL OUT TV Use HDMI cables (not supplied). If your TV supports the ARC function, you do not need to connect the digital optical cable (supplied). Refer to the Reference Guide for notes on HDMI connections. Notes • To output multi-channel digital audio, check the digital audio output setting on the device connected to the system. [. . . ] ΐ (remote control sensor)  (sensor del mando a distancia)  Display off/BLUETOOTH indicator Lights up in white when the system is on, not in BLUETOOTH mode, and the front panel display is off. Lights up in blue in BLUETOOTH mode (page 12). * When the display is turned from Off to On, audio format information appears on the display. ΐ SW TONE (page 10)  SW VOL (subwoofer volume) +/–  MENU/RETURN///ENTER (page 16)  SW TONE (página 10)  SW VOL (volumen del altavoz potenciador de graves) +/–  MENU/RETURN///ENTER (página 16) 15 Adjusting the settings / Ajuste de la configuración Press MENU on the remote control, then select the desired setting using //ENTER/RETURN. menu Function Default LEVEL DRC (DYNAMIC RANGE CONTROL) SYNC (AV SYNC) DUAL (DUAL MONO) S. OPT (SOUND OPTIMIZER) HEQ (HARMONICS EQUALIZER) AAV (ADVANCED AUTO VOLUME) CTRL (CONTROL FOR HDMI) You can enjoy Dolby Digital sound at low sound volumes. (ON/AUTO/OFF) ON: Compresses sound in accordance with the compression information contained in the content. aUTO: Automatically compresses sound encoded in Dolby TrueHD. You can adjust the sound when the image and the sound are not in sync. (1 – 4/ OFF) You can enjoy multiplex broadcast sound of Dolby Digital audio. (M/S (main and sub channels)/MAIN (main channel)/SUB (sub channel)) Adjusts the sound so that it is reproduced dynamically and more clearly even at low sound volumes. (ON/OFF) Reproduces the very low volume sounds that tend to be eliminated by audio compression. (ON/OFF) Note: HEQ functions only when “ANALOG/BT AU” is selected. This does not function with any other inputs, even though the item is displayed on the front panel. Reduces the volume discrepancies between different programs or between programs and commercials. (ON/OFF) Switches the Control for HDMI function on or off. (ON/OFF) For details , refer to the Reference Guide. Sets the power saving mode of the pass-through function of HDMI signals. (AUTO/ON) AUTO: Outputs signals from the HDMI OUT ARC (TV) jack of the system in standby mode when the TV is turned on. This setting saves power in standby mode compared with the “ON” setting. [. . . ] € Make sure this system is located not too far from the BLUETOOTH device, or the system is not subject to interference from a Wi‐Fi network, other 2. € Pair this system and the BLUETOOTH device again. € You may need to cancel the pairing with this system using your BLUETOOTH device first. No sound or only a very low-level sound of the connected equipment is heard from the system. [. . . ]