User manual SONY HVL-F10

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] 2 Care must be taken as burns can occur from touching hot parts. 3 Do not operate appliance if it has been dropped or damaged, until it has been examined by a qualified serviceman. 4 To reduce the risk of electric shock, do not immerse this appliance in water or other liquids. Design and specifications are subject to change without notice. This mark indicates that this product is a genuine accessory for Sony video products. When purchasing Sony video products, Sony recommends that you purchase accessories with this "GENUINE VIDEO ACCESSORIES" mark. You can enjoy shooting subjects with the camcorder in photo mode under the following conditions: Too much brightness behind the subject (backlighting) When you replace the batteries, be sure to use one new Sony CR123A lithium manganese battery. Use of another battery may present a risk of fire or explosion. To avoid damage from possible battery leakage, remove the batteries when you will not use the video flash for a long time. Clean the video flash with a dry soft cloth. In case of stubborn stains, use a cloth lightly dampened with a mild detergent solution, then wipe the unit clean with a dry soft cloth. Never use strong solvents, such as thinner or benzine, as these damage the surface finish. [. . . ] It takes longer for the video flash to charge as the batteries become older. ⷠThe video flash will need to recharge even if it is completely charged after: ­ you set the video flash POWER switch to OFF ­ you detach the video flash LANC control cable from the camcorder lLANC control jack ­ you set the camcorder POWER switch to any other position, i. [. . . ]