User manual SONY HVL-F20S

[. . . ] To reduce the risk of electric shock, do not disassemble this appliance, but take it to a qualified serviceman when service or repair work is required. Incorrect reassembly can cause electric shock when the appliance is used subsequently. The use of an accessory attachment not recommended by the manufacturer may cause a risk of fire, electric shock, or injury to persons. batteries may become hot or explode due to improper use. [. . . ] When carrying the camera with this unit attached, do not hold by this unit. Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. the recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product. Turn off the camera and remove this unit in the reverse sequence of attaching. After removing this unit from the camera, always fit the supplied connector protect cap onto the connector of this unit. Always remove from the camera before storing in a case, etc. For any service or guarantee matters please refer to the addresses given in separate service or guarantee documents. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. If you fire a flash directly at a subject just in front of a wall, harsh shadows appear on the wall (see illustration -). When shooting in a room with a low ceiling, you can soften these shadows by setting the BOUNCE switch to [BOUNCE] so that the flashtube of this unit tilts upward and emits light at the ceiling. Light reflects off the ceiling and illuminates the subject to produce a soft-lit image (see illustration -). When shooting outdoors, set the BOUNCE switch to [DIRECT] before using this unit. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Rotate the BOUNCE switch firmly until the mark is aligned with the desired position. The ceiling or wall that reflects the flash light should be white or very pale. If an image is under exposed (the shot looks dark), get closer to the subject, increase the ISO sensitivity or open the aperture more. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] Close supervision is necessary when any appliance is used by or near children. Do not leave appliance unattended while in use. Care must be taken as burns can occur from touching hot parts. Do not operate appliance with a damaged cord or if the appliance has been dropped or damaged- until it has been examined by a qualified serviceman. [. . . ]