User manual SONY HVL-HFL1

[. . . ] â· Remove the video flash light before putting the camcorder into a carrying case. â· Do not place anything over the ventilation grill. â· When the cover is hot do not allow it to get wet. â· The battery level may not be displayed correctly when using an "InfoLITHIUM" battery and "InfoLITHIUM" compatible camcorder with the video flash light. [. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Minutes using fully-charged battery pack) * When used with the LCD panel closed. 100 hours Video flash segment Flash life Approx. Be sure to switch from standby to OFF (CHG). Make sure the video light has cooled down before storing it. When recording indoors with this unit, you can get clear and beautiful color pictures. â· For wide angle shots, the video light may not light the corners of pictures completely. Use the video light for shooting the main subject of the picture effectively. Use of the video light may help to produce better pictures with less color blur. Design and specifications are subject to change without notice. Order the following parts number when purchasing the xenon lamp : A-1099-823-s. the lamp is hot when it has just burned out. Wait until the lamp cools down before removing it. Set the power switch of the video flash light to OFF before attaching or removing it from the camcorder. This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. this symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. CAUTION You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] â· This video flash light is compatible with camcorders that have an active interface shoe attached. The video flash light can therefore receive power via the camcorder. â· Video light ON/OFF is controlled with the camcorder in standby mode. When setting to AUTO, the video light comes on automatically in dark places. [. . . ]