User manual SONY HVL-LEIR1

[. . . ] The IR light enables recording at a distance of approximately 7 m when using the NightShot (Plus) function. The illuminance of white LED light and IR light can be adjusted continuously between 100% and 10% with the dimmer circuit installed. With the built-in color conversion filter, you can set this unit to two color temperatures, 5, 500 K or 3, 200 K, when using the white LED light. The IR light is compatible with a video camera with the NightShot (Plus) function. [. . . ] ?????????????????? ??????????????????????When attaching to a camera that has an accessory shoe, read the instruction manual of the camera too. If using a camera equipped with a pop-up built-in flash, be careful of the following: ??Always close the built-in flash of the camera. If your camera has a built-in auto flash function, turn that function off. ??Before using the flash, remove this unit from the camera. Make sure this unit is firmly fixed to the camera before use to prevent this unit from falling during shooting. ?????????????? To remove from the camera (illustration ?) Note ??When removing, be careful not to drop this unit or the camera. It is recommended that you attach the camera to a tripod before removing this unit. Html?????????? 1 Turn the POWER switch of this unit to OFF. 2 Rotate the lock dial of the shoe to the right to release the lock. 3 Check that the lock is released before sliding the shoe toward you. Before operating the unit, please read these instructions thoroughly, and retain them for future reference. Depending on the frequency of use of this unit, the shoe part may be scratched or cracked. This can cause this unit to be damaged or fall off. Do not attach this unit to the intelligent accessory shoe. Attaching the battery (illustration ?) Before attaching, check that this unit?s POWER switch is set to ?OFF. The following batteries (not supplied) can be used with this unit. Two Sony LR6 (size AA) alkaline batteries ??Two Sony AA Nickel-Metal Hydride batteries Notes ??The batteries may be hot after continuous use. When using alkaline batteries, light time may be much shorter. [. . . ] Pull the color conversion filter out from the filter storing slot as illustrated and fix it in place with the lock. When recording with this unit, if the subject is too close to the camera, several shadows of the subject may overlap (multi-shadow). The color temperature varies slightly depending on the position of the BRIGHT dial and temperature of the white LED. Check the white balance before recording. [. . . ]