User manual SONY HVL-80DA

[. . . ] 3 The remaining battery lamp lights up in steps as the remaining battery capacity is checked and calculated. 4 About 8 seconds after , the remaining battery capacity will be displayed. 5 After about 10 seconds, the remaining battery lamp will turn off. if you press the battery check button , the calculation or display function will be stopped. [. . . ] This Class B digital apparatus complies with Canadian ICES-003. If an error occurs for some reason during communication with the battery pack or if batteries other than the Sony "InfoLITHIUM" battery pack L series are inserted, 4 segments flash for 10 seconds to indicate a communication error and then the remaining battery display disappears. This product with the CE marking complies with both the EMC Directive (89/336/EEC) issued by the Commission of the European Community. Compliance with these directives implies conformity to the following European standards: · eN55103-1 :Electromagnetic Interference (Emission) · EN55103-2 :Electromagnetic Susceptibility (Immunity) This product is intended for use in the following Electromagnetic Environment(s): E1 (residential), E2 (commercial and light industrial), E3 (urban outdoors) and E4 (controlled EMC environment ex. The HVL-80DA is a video light that uses a high-brightness white LED as its lens light source. ⷠThe white LED has a long lifetime of about 10, 000 hours along with excellent impactresistance and weather-resistance qualities, and so requires hardly any maintenance. It is built to last and does need to be replaced. ⷠBy using the battery adaptor cord when the video light is attached to your camcorder, the weight of the camcorder is reduced and so is lighter to hold. When using batteries other than the Sony "InfoLITHIUM" battery pack L series (NP-F900 range, NP-F700 range) with the video light, the remaining battery capacity will not be displayed. ⷠWhen using a battery pack that only has a short lifetime remaining, the remaining battery display may not agree with the actual remaining battery capacity. ⷠWhen using a "InfoLITHIUM" battery pack attached to the "InfoLITHIUM" compatible AC adaptor/charger, the available operating time will not be displayed. ) Just before recording, insert the battery pack into the video light. ­ Charge the battery pack at room temperature (from 10 °C (50 °F) to 30 °C (86 °F)). ⷠWhen you have finished using the video light, be sure that the POWER switch on the video light is set to OFF. ⷠWhen not using the video light or when you have finished using it, remove the battery pack. ⷠDo not store away the video light immediately after using it. The white LED may be damaged by the generated heat. Check that the power of the video light is set to OFF and the video light has cooled sufficiently before storing it in your bag, etc. ⷠLeaving the condenser lens in direct sunlight while closed could cause a malfunction. Leaving the condenser lens in direct sunlight while open could cause fire near the focal point of the lens. ⷠRecording with the video light attached to the video camera body can slightly affect the recorded sound. 2 Slide the battery release button and at the same time pull the battery pack upward. [. . . ] Attaching the video light to the concave screw 1 Turn the light attachment knob on the video light toward LOCK to extend the screw. 2 Align the screw part of the video light with the concave screw. 3 Turn the light attachment knob on the video light toward LOCK to fasten the video light. Attaching the video light to the convex screw on the tripod or grip 1 Turn the light attachment knob on the video light toward RELEASE as far as it will go, in order to retract the screw. [. . . ]