User manual SONY ICD-30

[. . . ] Two note files ­­ The ratio of the recording time for these files is adjustable within the maximum recordable time of this unit. Flash memory to keep notes recorded even without a battery This IC recorder automatically records notes after the last recorded note so that you can start recording quickly without searching for the end of the last recording. You can record up to 99 notes in each file, A and B. When you record all notes in SP (standard play) mode, you can record for 8 minutes and in LP (long play) mode for 16 minutes . [. . . ] An index mark is added and the following index numbers will increase by one. Index numbers increase by two New note To return to the normal mode Select "OFF" in step 2. When there are already 98 notes recorded in the file, you cannot insert a new recording. To erase a note partially Before you do steps 1 and 2, divide the note into the part to erase and the part not to erase by adding an index mark. Inserting a new note between two notes Press + or = to select the index number before which you want to insert a new note. Press and hold REC for more than a second until "InS" appears and flashes, and then speak into the microphone. The new note is added and the notes after that are renumbered as follows. Press pSTOP and ERASE at the same time for about a second during stop mode. To return to the normal mode Select "OFF" in step 2. Playing a note using timer Various ways of playing You can set the unit to play a note automatically on a chosen day and time with the alarm. You cannot set the alarm if you have not set the clock on the unit. Also, you cannot use the alarm if you have not recorded any note. 1 Select the file and the index number you want to play with an alarm by pressing FILE and =/+. "mon" to "Sun", the note is played back only on that day within a week. When the set day and time come, the alarm rings for 10 seconds and then the note is played. You can add or erase index marks after recording. Press ( for more than a second until " " appears while the unit is playing the desired note. The unit will play the note over and over again. To return to the normal play Briefly press (. To stop the note from playing Press pSTOP while the alarm sounds, otherwise the note starts playback. even if the HOLD switch is on , you can stop the note. To play the note before alarm sound finishes Press pSTOP and (. [. . . ] The notes are then combined and unit returns to the normal mode. You can cut off the beep sound by following the steps below. The alarm still sounds even if you set the beep sound off. This warranty is valid only in the United States. [. . . ]