User manual SONY ICF C1

[. . . ] Ώ Dispose of used battery promptly and in accordance with local environmental laws and guidelines. Operations Setting the clock manually To change the clock setting manually, operate the unit as follows. Setting the sleep timer You can fall asleep to the radio using the sleep timer, which turns off the radio automatically after a preset duration. Ώ Do not operate the unit over a steel desk or metal surface, as this may lead to interference. [. . . ] (See “Setting the clock manually. €)  To set the radio alarm, first tune to a station and adjust the volume. General information About the battery as a backup power source This unit contains a CR2032 battery as a backup power source to keep the clock operating during a power interruption. To set the alarm 1 Set ALARM MODE to the desired alarm sound (RADIO or BUZZ). lecture de la radio 1 Appuyez sur RADIO pour allumer la radio. AC power cord Cordon secteur Netzkabel FM wire antenna Cordon d’antenne FM FM-Kabelantenne There is a tactile dot beside VOLUME + to show the direction to go to turn up the volume. Setting the clock for the first time All you need to do to set the clock for the first time is select your time zone. If you live in the Central European Time zone, you do not need to adjust the area setting. Area number “1” appears on the display. The alarm time appears for a few seconds, and then “ ” appears on the display. (It does not appear when the switch is set to OFF. ) When to replace the battery When the battery is discharged, “” appears on the display. If a power interruption occurs while the battery is discharged, the current time and alarm will be erased. 2 Press TIME ZONE repeatedly to select a number as follows: Area number Time zone 0 1 (default) Western European Time Central European Time Eastern European Time 2 Press SET ALARM TIME + or – repeatedly to set the desired time while the alarm time appears on the display. While setting the alarm time, “ ” flashes on the display. When the alarm time setting operation is complete, the clock display returns after a few seconds and “ ” changes from flashing to fully lit. At the set time, the radio will turn on, or the buzzer will sound gradually increasing in volume. (“ ” flashes on the display. ) Note for customers in Europe  The clock is preset at the factory, and its memory is powered by the preinstalled Sony CR2032 battery. If the “0:00” flashes on the display when the unit is connected to AC outlet for the first time, the battery may be discharged. The preinstalled CR2032 battery is considered part of the product, and is covered by the warranty. You are required to show “Note for customers in Europe” (in this instruction) to a Sony dealer in order to validate the warranty for this product. [. . . ] For more detailed information about recycling of this product or battery, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product or battery. The display shows the snooze time for about 4 seconds and returns to show the current time. 3 Insert the battery compartment back into the unit along the groove and push it from above until it clicks. Note  The implementation of DST/summer time and its beginning/ending date and time are subject to circumstances and laws in each country/region. [. . . ]