User manual SONY ICF-C160

[. . . ] Before operating the Dream Machine, please read these instructions thoroughly and retain them for future reference. An appliance and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the appliance and cart combination to overturn. [. . . ] wHEN INSTALLING AN OUTDOOR ANTENNA SYSTEM , EXTREME CARE SHOULD BE TAKEN TO KEEP FROM CONTACTING SUCH POWER LINES OR CIRCUITS AS CONTACT WITH THEM IS ALMOST INVARIABLY FATAL. Be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. Unplug the appliance from the wall outlet and consult qualified service personnel when: -the power cord or the plug has been damaged. Do not attempt to service the appliance beyond that described in the operating instructions. To keep good time, your Dream Machine needs one 6F22 battery (not supplied), in addition to house current. The battery keeps the clock operating in the event of a power interruption. Before setting the time on your Dream Machine, open the lid at the bottom of the unit, install the battery with correct polarity and then close the lid. ⷠAfter a power interruption, the displayed time may not be always correct (It may gain or lose about 10 minutes per hour). Enjoy falling asleep to the radio using the built-in sleep timer that shuts off the radio automatically at a preset time. To check battery power, unplug the power cord from the wall outlet and plug it in again after a few minutes. If the displayed time is incorrect, replace the battery with a new one. You can set the sleep timer of 90, 60, 45, 30 or 15 minutes. Every push changes the display as follows. [. . . ] Battery Design and specifications are subject to change without notice. While holding down ALARM A RADIO (for the radio) or B BUZZER (for the buzzer), press TIME SET + or ­ until the desired time appears in the display. When you release ALARM A or B, the ALARM A or B indicator stops flashing and lights up, and the current time appears in the display. [. . . ]