User manual SONY ICF-C180

[. . . ] If you are on daylight saving time, refer to "To change the display to the daylight saving time (summer time) indication" to active the summer time function. During the shipment and your first use, a clock error may occur. In this case, refer to "Setting the Clock" to set the correct time. Each turn of ALARM TIME SET + or ­ changes the indication on the display as follows: Set the clock according to the following steps. [. . . ] If the power source returns within 60 minutes of the set alarm time, the alarm sounds. (If the alarm repeats 5 times, the alarm sounds up to 30 minutes. ) · If "E" appears on the display, the alarm will not work in the event of power interruption. Select BRIGHTNESS to HIGH or LOW for the display, according to your preference. Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. the recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. Model for other countries/ regions: Modèle pour les autres pays ou régions : To keep good time, this unit has one CR2032 battery (supplied), in addition to the house current. The battery keeps the clock operating in the event of a power interruption. For Canada model, the battery has already been installed in the unit. Keep the AC plug connected to the AC outlet, insert a pointed object into the hole beside the battery compartment to eject the tray and then pull out. A-1) Install a new battery in the tray with the E side facing forward. A-3) When you are replacing the battery, press RADIO ON to turn "E" off on the display. Model for other countries/ regions: Extend the FM wire antenna fully to increase reception sensitivity. Using the NAP timer (count down timer) The NAP timer sounds the buzzer after a preset time duration. press NAP repeatedly until the desired minute appears. Each press changes the display as follows: Models for United Kingdom and Eastern Europe Note If you replace the battery, do not disconnect AC plug from AC outlet. If the "AM 12:00" flashes on the display when the unit is connected to AC outlet for the first time, the battery may be weak. You are required to show "Note for customers in Canada" (in this instruction) to a Sony dealer in order to validate the warranty for this product. [. . . ] You can select the alarm mode to either weekday or weekend. Setting the Clock for the first time (Canada model only) This unit is preset to the current EST (Eastern Standard Time) at the factory, and is powered by the back up battery. All you need to do the first time is just plug it in, select your time zone, and activate the DST/Summer time if necessary. To turn off the radio before the preset time Example: Display window when you set weekend and alarm A. [. . . ]