User manual SONY ICF-C1IPBLACK

[. . . ] 3-272-042-11(2) Owner's Record The model number and the serial number are located on the rear exterior. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. ICF-C1iP Serial No. Important Safety Instructions Read these instructions. [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. WARNING · Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. · Replace the battery for the clock backup with a Sony CR2032 lithium battery, and the battery for the remote commander with a Sony CR2025 lithium battery. Use of another battery may present a risk of fire or explosion. · Battery may explode if mistreated. Do not recharge, disassemble or dispose of in fire. · Do not expose the battery to excessive heat such as direct sunlight, fire or the like. · Dispose of used battery promptly. This unit includes a preinstalled Sony Lithium battery (CR2032) as back-up power source for the clock, which is preset to EST/EDT (Eastern Standard Time/Daylight Time) at the factory. And this battery is considered part of the product. About the backup battery To keep good time, as a backup power source, this unit has one CR2032 battery inside of the unit in addition to the house current. The battery keeps the clock and the alarm operating in the event of a power interruption. Note During the shipment and your first use, a clock error may occur. In this case, refer to "Setting the clock and date" to set the correct time. 1 Put the iPod into the unit's connector. Playing the radio --Manual Tuning 1 Press RADIO ON to turn on the radio. The display shows the band and frequency. Tuning into a preset station 1 Press RADIO ON to turn on the radio. 2 Press one of the PRESET TUNING buttons where the desired station is stored. Setting the sleep timer You can fall asleep to the sound using the built-in sleep timer that turns off the unit automatically after a preset duration. When daylight saving time (summer time) begins This model employs the Automatic Daylight Saving Time/Summer Time adjustment. The DST indicator in the display appears in the display at the beginning of the daylight saving time (summer time), and disappears at the end of it. · Daylight saving time begins at: 2:00 AM on the second Sunday of March. · Standard time begins at: 2:00 AM on the first Sunday of November. 3 Adjust volume using VOLUME. 1 Press SLEEP while the unit is turned on. SLEEP appears in the display. Knowing when to replace the battery If a power interruption occurs when the battery is weak, the brightness of characters in the display darkens. If the battery runs out during the interruption, the current time and alarm functions will be initialized. Replace the battery with a Sony CR2032 lithium battery. Use of another battery may present a risk of fire or explosion. Setting the alarm 2 Press RADIO ON repeatedly to select the desired band. Each press changes the band as follows: The dual alarm function allows you to set two alarm programs (ALARM A and ALARM B). [. . . ] · To use an iPod, refer to the user's guide of your iPod. · Before disconnecting the iPod, pause playback. Tip Apple's iPod Universal Dock Adapter can be used with this unit. To doze for a few more minutes To preset another station, repeat these steps. To change the preset station, tune into the desired station and hold down the PRESET TUNING 1 to 5 button. [. . . ]