User manual SONY ICF-C263

[. . . ] · Do not leave the unit in a location near a heat source such as a radiator or airduct, or in a place subject to direct sunlight, excessive dust, mechanical vibration, or shock. · Do not place the unit on surfaces (rugs, blankets, etc. ) or near materials (curtains, draperies) that block the ventilation holes. · Should any liquid or solid object fall into the unit, unplug the unit and have it checked by qualified personnel before operating it further. · When the casing becomes soiled, clean it with a soft cloth dampened with a mild detergent solution. [. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/ TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. When not in use Unplug the power cord of the appliance from the outlet when left unused for a long period of time. To disconnect the cord, pull it out by grasping the plug. Never pull the plug out by the cord. Printed on 100% recycled paper using VOC (Volatile Organic Compound)free vegetable oil based ink. 2004 Sony Corporation Printed in China Power-Cord Protection Route the power cord so that it is not likely to be walked on or pinched by items placed upon or against them, paying particular attention to the plugs, receptacles, and the point where the cord exits from the appliance. Lightning For added protection for this appliance during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the appliance due to lightning and powerline surges. Object and Liquid Entry Specifications Time display 12-hour system Frequency range FM: 87. 5 - 108 MHz (Channel step 0. 1 MHz) AM: 530 - 1, 710 kHz (Channel step 10 kHz) Speaker Approx. 8 Power output 150 mW (at 10 % harmonic distortion) Power requirements 120 V AC, 60 Hz Dimensions Approx. 172. 5 × 61. 9 × 154. 7 mm (w/h/d) (6 7/8 × 2 1/2 × 6 1/8 inches) including projecting parts and controls Mass Approx. 610 g (1 lb 21. 5 oz) Design and specifications are subject to change without notice. Never push objects of any kind into the appliance through openings as they may touch dangerous voltage points or short out parts that could result in a fire or electric shock. Never spill liquid of any kind on the appliance. Cleaning Unplug the appliance from the wall outlet before cleaning or polishing it. Do not use liquid cleaners or aerosol cleaners. Use a cloth lightly dampened with water for cleaning the exterior of the appliance. Clean the appliance only as recommended by Sony. Attachments Do not use attachments not recommended by Sony, as they may cause hazards. ANTENNAS Outdoor Antenna Grounding If an outdoor antenna or cable system is installed, follow the precautions below. An outdoor antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can come in contact with such power lines or circuits. WHEN INSTALLING AN OUTDOOR ANTENNA SYSTEM, EXTREME CARE SHOULD BE TAKEN TO KEEP FROM CONTACTING SUCH POWER LINES OR CIRCUITS AS CONTACT WITH THEM IS ALMOST INVARIABLY FATAL. Be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. Antenna Grounding According to the National Electrical Code Antenna Lead-in Wire Ground Clamps Electric Service Equipment NEC-NATIONAL ELECTRICAL CODE Antenna Discharge Unit (NEC Section 810-20) Grounding Conductors (NEC Section 810-20) Ground Clamps Power Service Grounding Electrode System (NEC Art 250 Part H) SERVICE Damage Requiring Service Unplug the appliance from the wall outlet and refer servicing to qualified service personnel under the following conditions: -When the power cord or plug is damage or frayed. -If liquid has been spilled or objects have fallen into the appliance. [. . . ] AM: Rotate the unit horizontally for optimum reception. Do not operate the unit over a steel desk or metal surface, as this may lead to interference of reception. 1 2 3 Perform steps 1 to 5 in "To set the Alarm Time". Press TUNE/TIME SET + or ­ to select "RADIO" alarm mode. Press ALARM SET A or B to select the desired wake-up station. After one beep, "WAKE UP" appears and the preset number flashes on the display. To Deactive NAP Timer Press NAP. [. . . ]