User manual SONY ICF-C317L

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. [. . . ] To set the current time rapidly, keep pressing the + or ­ button while holding down CLOCK. ⷠTo set the current time from zero seconds, at step 2, release CLOCK with the time signal. You can also assign a countdown time of your choice to each of the five preset buttons. Then the current time indication will return to the display. Hold down the desired PRESET TUNING/PRESET TIMER button until you hear two short beeps. There are two bands for FM (FM1 and FM2); you may listen to either band. Secure the suction cup on the wall where you get optimum reception. When you assign a countdown time to a preset button, the default countdown time assigned to the button will be overwritten by the new one. However, the preset countdown time will return to the default setting when the batteries are reset. ⷠTo check the station you are listening to, press TUNE/TIMER ADJUST + or ­ lightly. The AUTO OFF function will turn off the radio after a preset duration of time. If you have any questions, please consult your nearest Sony dealer. Splash resistant; you can listen to the radio while taking a shower. AUTO OFF function automatically turns off the radio after a preset duration. 5 memory presets buttons to preset your favorite stations for easy tuning. The frequency will appear for a few seconds and then the display will return to the current time. ⷠTo change the preset station, preset a new station to the button of your choice. Install three R14 (size C) batteries (not supplied) with correct polarity and close the lid until it clicks. After a few seconds, the display will return to the current time but the preset tuning number indication will remain. The buzzer alarm is operable whether or not the radio is on. The countdown time can be set at 1 minute intervals between 1 to 90 minutes. When the batteries become weak, the sound becomes weak and distorted and "i" flashes. [. . . ] Otherwise, the memories for the clock and the preset stations will be erased and "AM 12:00" or "0:00" will flash in the display the next time the batteries are installed. ⷠTo preserve clock and memory settings, keep unexhausted batteries in the radio even when you are not going to use the unit for a long time. Replace the batteries with new ones in about a year, since battery power is consumed even in this condition. While " " is in the display, press TUNE/TIMER ADJUST + or ­ until the desired countdown time appears in the display. [. . . ]