User manual SONY ICF-C390

[. . . ] -An appliance and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the appliance and cart combination to overturn. If your appliance can be mounted to a wall or ceiling, mount it only as recommended by Sony. This appliance should be operated only from the type of power source indicated on the marking label. [. . . ] Do not use attachments not recommended by Sony, as they may cause hazards. An outdoor antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can come in contact with such power lines or circuits. wHEN INSTALLING AN OUTDOOR ANTENNA SYSTEM , EXTREME CARE SHOULD BE TAKEN TO KEEP FROM CONTACTING SUCH POWER LINES OR CIRCUITS AS CONTACT WITH THEM IS ALMOST INVARIABLY FATAL. Be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. Full power backup to keep the clock and the alarm (radio and buzzer) during a power interruption with a 6F22 battery (not supplied) installed. This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. this symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. The graphical symbols are on the bottom enclosure. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. To keep good time, your Dream Machine needs one 6F22 battery (not supplied), in addition to house current. The battery keeps the clock operating in the event of a power interruption. Before setting the time on your Dream Machine, open the lid at the bottom of the unit, install the battery with correct polarity and then close the lid. â· After a power interruption, the displayed time may not be always correct (It may gain or lose about 10 minutes per hour). To check battery power, unplug the power cord from the wall outlet and plug it in again after a few minutes. If the displayed time is incorrect, replace the battery with a new one. Unplug the appliance from the wall outlet and refer servicing to qualified service personnel under the following conditions: -When the power cord or plug is damage or frayed. -If the appliance does not operate normally when following the operating instructions, adjust only those controls that are specified in the operating instructions. Improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the appliance to normal operation. -If the appliance has been subject to excessive shock by being dropped, or the cabinet has been damaged. [. . . ] If you set ALARM A and ALARM B at the same desired time, only ALARM A will work. To cancel either alarm, while holding down the ALARM A or ALARM B button, press RADIO OFF/ALARM RESET/OFF. The alarm will shut off, but will come on again after about 6 minutes. You can repeat this process as many times as you like. [. . . ]