User manual SONY ICF-C705

[. . . ] ⷠDo not connect the antenna lead to the external antenna. If you have any questions, please consult your nearest Sony dealer. 1 MHz and the AM channel step is set to l0 kHz for the model for the North and South America. 05 MHz and the AM(MW) channel step is set to 9 kHz for the model for other countries. [. . . ] A beep sounds when the upper or lower extremity of the band range is reached. The Dream Machine will give you many hours of reliable service and listening pleasure. Before operating the Dream Machine, please read these instructions thoroughly and retain them for future reference. These instructions cover these models: ICF-C705 and ICF-C705L. Digital voice memo which you can also use for the wake up memo mode. ⷠDate button to display the year, month and date. LCD with backlight which has a brightness switch. ⷠSelf power back-up: Even if the power supply is interrupted, the time setting and the memory will be back up for half an hour without batteries. The band and frequency are displayed for a few seconds, after which the current time indication returns to the display. ⷠIf the radio alarm A RADIO comes on while the radio is playing, the station switches to the frequency set under preset number 1. Only one message can be recorded and up to about 20 seconds. ⷠWhen using the radio alarm, preset the station you wish to serve as the alarm under preset button 1. When the alarm time is reached, the radio or buzzer sounds for 60 minutes or until turned off. Press TUNE/TIME SET + or ­ until the correct year appears in the display. Repeat steps 3 and 4 to set the month, date, hour, and minute. After setting the minute, press and release CLOCK to start the counting of the seconds. Should any problem occur with the unit, make the following simple checks to determine whether or not servicing is required. if the problem persists , consult the nearest Sony dealer. The clock does not show the correct time. ⷠHas an electrical power outage lasting more than half an hour occurred?12 hour 24 hour To display the year and date, press SNOOZE/ DATE/SLEEP OFF once for the date and within 2 seconds press it again for the year. The date or year will appear in the display for a few seconds and then the display returns to the current time. [. . . ] 12 hour 24 hour To display the year and date, press SNOOZE/ DATE/SLEEP OFF once for the date and within 2 seconds press it again for the year. The date or year will appear in the display for a few seconds and then the display returns to the current time. When SNOOZE/DATE/SLEEP OFF is pressed while the SNOOZE function is operating, the year and date will not appear in the display. To set the current time from zero seconds, release CLOCK with the time signal at step 5. [. . . ]