User manual SONY ICF-C707

[. . . ] 4-180-721-11(1) FM/AM Clock Radio Operating Instructions For customers who purchased this product in the USA Please register this product on line at http://www. sony. com/productregistration. Proper registration will enable us to send you periodic mailings about new products, services, and other important announcements. Registering your product will also allow us to contact you in the unlikely event that the product needs adjustment or modification. Thank you. Important Safety Instructions 1) 2) 3) 4) 5) 6) 7) Read these instructions. [. . . ] 190 mm × 67 mm × 62 mm (w/h/d) (7 1/2 inches × 2 3/4 inches × 2 1/2 inches) not including projecting parts and controls Mass Approx. 620 g (1 lb 5. 87 oz) including power supply unit and CR2032 battery Supplied accessories AM loop antenna (1) Design and specifications are subject to change without notice. This unit includes a preinstalled Sony Lithium battery (CR2032) as back-up power source for the clock, which is preset to EST (Eastern Standard Time) at the factory. And this battery is considered part of the product. Built-in audio cable Setting the clock for the first time This unit is preset to current EST (Eastern Standard Time) at the factory, and is powered by a backup battery. All you need to do the first time is just plug it in and select your time zone. Notes While setting the clock, you must perform each step within 65 seconds, or the clock setting mode will be cancelled. When pressing any of the rear buttons, hold the unit firmly to prevent slippage. Improving the reception FM: Extend the FM wire antenna fully to increase reception sensitivity. AM: Connect the supplied AM loop antenna to the unit. Rotate the antenna horizontally for optimum reception. 3 Press TIME SET + or ­ to select the 4 To display the year and date Press DATE/TIME ZONE once for the year, and press again for the date. After a while, the display will change back to the current time automatically. NATURE SOUND / PRESET 1 to 5, and press ALARM ON/OFF A or B. Improper use of the external temperature sensor may cause a malfunction. The display temperature and actual temperature may differ depending on the usage environment. Do not place the temperature sensor near the floor, a heat source such as a radiator or airduct, or in a place subject to direct sunlight. The temperature sensor reading may differ from actual surrounding temperature. The operating temperature range is 5 °F (­15 °C) to 122 °F (50 °C). In the case of lower than 5 °F (­15 °C) or higher than 122 °F (50 °C), the "Lo" or "Hi" indicator appears. When plugging in the unit or recovering from a power interruption, the temperature display of this unit will flash "--". The temperature will be displayed after 20 seconds. Selecting a Nature Sound This unit includes 5 types of Nature Sounds: (Sea Waves, Birds, Rain, Brook and Under the Sea. ) You can choose any one of these by pressing the corresponding button. Icons Sound type Sea Waves Birds Rain Brook Under the Sea Note When other functions are in use, Nature Sound is not available. Setting the radio alarm 1 Perform steps 1 to 5 in "To set the alarm. " 2 Press TIME SET + or ­ to select "RADIO" alarm mode, and press ALARM ON/OFF A or B. To doze for a few more minutes Note When the alarm is sounding, the brightness function cannot be used. 3 Press TIME SET + or ­ to select the "RADIO" appears in the display. Press SNOOZE / BRIGHTNESS. The sound turns off but will automatically come on again after about 10 minutes. You can change the snooze time by pressing SNOOZE / BRIGHTNESS repeatedly within 4 seconds. The maximum snooze time is 60 minutes. To stop the alarm AM band, FM band or the last station, and press ALARM ON/OFF A or B. Playing the radio Manual tuning 1 Press RADIO BAND to turn on the 2 3 radio and select the AM or FM band. Press TUNING + or ­ to tune in to a desired frequency. Adjust the volume using VOL + or ­. 4 Press TIME SET + or ­ to select the 5 If you select the last station, jump to step 5. Press OFF ALARM RESET to turn off the alarm. [. . . ] 2 Hold down the desired NATURE SOUND / PRESET 1 to 5 button until you hear two beeps. Example: The following display appears when you preset FM 105. 7 MHz to preset number 3 for FM. To set the alarm 1 Press and hold ALARM ON/OFF A or 2 Press TIME SET + or ­ to set the 3 B for a few seconds. desired hour, and press ALARM ON/ OFF A or B. Press TIME SET + or ­ to set the desired minute, and press ALARM ON/ OFF A or B. 1 Press SLEEP while the unit is turned on. "SLEEP" appears and the sleep time flashes in the display. 2 Press SLEEP to set the sleep timer duration. 90 To return to the radio Each time you press SLEEP, the duration (in minutes) changes as follows: 60 OFF 30 15 Press RADIO BAND. The frequency is shown in the display. To stop listening Press OFF ALARM RESET, and stop playback on the connected unit. 4 Press TIME SET + or ­ to set the desired alarm period ("WEEKDAY, " "WEEKEND" or everyday*), and press ALARM ON/OFF A or B. * In the case of everyday, both "WEEKDAY" and "WEEKEND" are displayed. The display shows the frequency for a few seconds and then changes back to the current time. [. . . ]