User manual SONY ICF-C713

[. . . ] · Do not leave the unit in a location near a heat source such as a radiator or airduct, or in a place subject to direct sunlight, excessive dust, mechanical vibration, or shock. · Allow adequate air circulation to prevent internal heat build-up. Do not place the unit on a surface (a rug, a blanket, etc. ) or near materials (a curtain) which might block the ventilation holes. · Should any solid object or liquid fall into the unit, unplug the unit and have it checked by a qualified personnel before operating it any further. [. . . ] Do not defeat the safety purpose of the grounding plug. INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/ TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. CAUTION The use of optical instruments with this product will increase eye hazard. Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION With 4-ohm loads, both channels driven from 150-6 000 Hz; rated 1. 2 W per channelminimum RMS power, with no more than 10% total harmonic distortion in AC operation. Overloading Do not overload wall outlets, extension cords or convenience receptacles beyond their capacity, since this can result in fire or electric shock. When not in use Unplug the power cord of the appliance from the outlet when left unused for a long period of time. To disconnect the cord, pull it out by grasping the plug. Improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the appliance to normal operation. -If the appliance has been subject to excessive shock by being dropped, or the cabinet has been damaged. Servicing Do not attempt to service the appliance yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel. Replacement parts When replacement parts are required, be sure the service technician has used replacement parts specified by Sony that have the same characteristics as the original parts. Unauthorized substitutions may result in fire, electric shock, or other hazards. Safety Check Upon completion of any service or repairs to the appliance, ask the service technician to perform routine safety checks (as specified by Sony) to determine that the appliance is in safe operating condition. AC power cord Cord clamp Installing the Unit Under a Cabinet (See Fig. A) The unit can be installed without the spacer. Playing a CD An 8 cm (3-inch) CD can be played without an adaptor. Various Modes of CD Playback You can play tracks repeatedly or in random order. Preset Tuning You can preset 10 stations in FM (5 stations in FM1, 5 stations in FM2) and 5 stations in AM. 1 Press OPEN/CLOSE Z and place a CD on the disc tray. Press CD PLAY MODE. Each press changes the play mode as follows: Display indication Play mode Presetting a Station Example: To preset FM90 MHz onto preset button 2 for FM2. 1 2 3 Mark the position of the 4 holes by using the supplied template. Use a drill to make the holes (size 6. 5 mm dia. , 9/32 inch). A- ) When the cabinet door overhangs the shelf and obstructs the unit, you can adjust the unit/shelf height. First set the L mark to the dot which becomes the lowest position, then you can adjust the height in 4 steps (H··L) by turning the spacer counterclockwise. A- ) Install the unit with the supplied mounting screws. A- ) 1 < none (normal play) 2 3 4 All the tracks are played once. [. . . ] Adjust the volume using VOLUME. After a few seconds, the display returns to the current time but the preset button number remains. Note When the PRESET TUNING buttons (1-5) are pressed lightly, the radio station that is preset will be selected. When they are pressed for a while, the station that is on will be newly preset. Manual Tuning 1 Press RADIO ON·BAND to turn on the radio. "RADIO" appears in the display. The display shows the band and frequency for a few seconds and then changes back to the current time. 2 Press RADIO ON·BAND repeatedly to select the desired band. [. . . ]