User manual SONY ICF-C763

[. . . ] Owner's Record 3-266-173-21(1) The model number and the serial number are located on the bottom. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. ICF-C763 Features · Dual alarm FM/AM PLL (Phase Locked Loop) synthesized clock radio. [. . . ] -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/ TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Object and Liquid Entry Never push objects of any kind into the appliance through openings as they may touch dangerous voltage points or short out parts that could result in a fire or electric shock. Never spill liquid of any kind on the appliance. Cleaning Unplug the appliance from the wall outlet before cleaning or polishing it. Do not use liquid cleaners or aerosol cleaners. Use a cloth lightly dampened with water for cleaning the exterior of the appliance. Clean the appliance only as recommended by Sony. Attachments Do not use attachments not recommended by Sony, as they may cause hazards. ANTENNAS Outdoor Antenna Grounding If an outdoor antenna or cable system is installed, follow the precautions below. An outdoor antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can come in contact with such power lines or circuits. WHEN INSTALLING AN OUTDOOR ANTENNA SYSTEM, EXTREME CARE SHOULD BE TAKEN TO KEEP FROM CONTACTING SUCH POWER LINES OR CIRCUITS AS CONTACT WITH THEM IS ALMOST INVARIABLY FATAL. Be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. Specifications Time display 12-hour system Frequency range FM: 87. 5 - 108 MHz AM: 530 - 1 710 kHz Speaker Approx. 4 Power output 200 mW (at 10 % harmonic distortion) Power requirements 120 V AC, 60 Hz Dimensions Approx. 115. 5 × 105 × 110. 6 mm (w/h/d) (4 5/8 × 4 1/4 × 4 3/8 inches) including projecting parts and controls Mass Approx. 600 g (1 lb 5. 2 oz) Design and specifications are subject to change without notice. Antenna Grounding According to the National Electrical Code Antenna Lead-in Wire Ground Clamps Electric Service Equipment NEC-NATIONAL ELECTRICAL CODE Antenna Discharge Unit (NEC Section 810-20) Grounding Conductors (NEC Section 810-20) Ground Clamps Power Service Grounding Electrode System (NEC Art 250 Part H) SERVICE Damage Requiring Service Unplug the appliance from the wall outlet and refer servicing to qualified service personnel under the following conditions: -When the power cord or plug is damage or frayed. -If liquid has been spilled or objects have fallen into the appliance. -If the appliance has been exposed to rain or water. -The appliance does not appear to operate normally or exhibits a marked change in performance. -If the appliance does not operate normally when following the operating instructions, adjust only those controls that are specified in the operating instructions. Improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the appliance to normal operation. -If the appliance has been subject to excessive shock by being dropped, or the cabinet has been damaged. Servicing Do not attempt to service the appliance yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Repeat steps 2 and 3 to set the minute. A beep sounds to confirm the setting of time. AM SNOOZE/SLEEP OFF FM1 FM2 When using FM1 or FM2 preset mode, you may listen to the radio on either mode. [. . . ] To change the display to the daylight saving time (summer time) indication Press D. S. T. /CLOCK. " " is displayed and the time indication changes to summer time. To deactivate the summer time function, press D. S. T. /CLOCK again. Press RADIO ON·OFF to turn off the power. While holding down BAND, keep pressing RADIO ON·OFF for more than 5 seconds. Two short beeps sound, and the AM channel step will be changed. [. . . ]