User manual SONY ICF-CD553

[. . . ] 3-265-482-11(1) WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. [. . . ] The display shows the band and frequency for a few seconds and then changes back to the current time. (See Fig. A) The unit can be installed without the spacer. 1 Press Z CD OPEN/CLOSE and place a CD on the disc tray. Switching between monaural and stereo The radio is set for stereo reception at the default setting. If FM stereo reception is poor, set to "FM MONO (monaural)". Noise will be reduced although the sound will not be heard in stereo. Operating the Cooking Timer (Countdown Timer) The timer can be set at one minute intervals between 1­120. Push 1 2 TIMER indicator AC power cord 3 Mark the position of the 4 holes by using the supplied template. Use a drill to make the holes (size 6. 5 mm dia. , 9/32 inch). A- ) If the cabinet door overhangs the shelf and obstructs the unit, you can adjust the unit/ shelf height. First set the L mark to the dot which becomes the lowest position, then you can adjust the height in 4 steps (H··L) by turning the spacer counterclockwise. A- ) Install the unit with the supplied mounting screws. A- ) 1 2 Press RADIO ON/BAND repeatedly to select the desired band. Each press changes the band as follows: AM FM1 FM2 1 2 3 2 3 4 To Press Z CD OPEN/CLOSE to close the disc tray. Press CD u. "NCD" and "TRACK 01" appear on the display to indicate that track 1 of the CD is playing. TV WEATHER When using FM1 or FM2 preset mode, you may listen to the radio on either mode (See "Presetting Your Favourite Station"). Press RADIO ON/BAND to turn on the radio. Press RADIO ON/BAND repeatedly to select FM 1 or FM 2. Press MODE. "Mono(monaural)" or "ST(Stereo)" appears in the display. Each time you press MODE, the mode changes to either "Mono" or "ST". Turn TIMER until the desired time appears in the display. "TIMER" will appear in the display when TIMER is turned. After setting the time, the current time is displayed again if you do not perform any operation for more than 65 seconds. 2 Push TIMER once. Timer indicator lights and beep sounds. While the timer is set, the display shows the remaining time. 3 Adjust volume using VOLUME + or ­. Press CD u CD u again . ** >** Hold down . ** Hold down >** . repeatedly** > repeatedly** x OFF Use TUNE·TIME SET + or ­ to tune in to the desired station. Two short beeps sound when the minimum frequency of each band is received during tuning. 4 Select Mono or ST. The mode you select appears in the display for a few seconds and returns to the current time. To display the current time, press CLOCK. Cooking Timer ON-- When the time has elapsed, the buzzer will sound and the TIMER indicator flashes. Even if the CD or the radio is being played, the buzzer of the timer sounds together. While the buzzer sounds, the volume of the CD or the radio is decreased. The volume returns to the previous volume level when the buzzer stops. RADIO TV AM WEATHER FM12 PM TIMER CD MHz kHz SHUFFLE REP 1 ALL VOL TRACK MEGABASS MEGAXpand TIMER PUSH START/STOP MODE REC MESSAGE SOUND 12345 The preset 3, VOLUME + and CD u buttons have a tactile dot. PRESET TUNING / MESSAGE VOLUME TUNE CD OPEN/ CLOSE MESSAGE REC/STOP PLAY/STOP CD RADIO ON BAND OFF 1 2 STATION 3 SELECT/ 4 PRESET 5 TIME SET MIC A Template Spacer L (Low) Dot Caution · Since the unit is very heavy, be careful when installing the unit. · Hold the unit horizontally when installing it, since the CD tray may open if the unit is shaken. · To reduce the risk of fire, do not place any heating or cooking appliance beneath this unit. [. . . ] Adjust the volume using VOLUME + or ­. After a few seconds, the display returns to the current time but the PRESET TUNING button number remains. Note Holding down the desired PRESET TUNING/ MESSAGE button for more than a few seconds in step 3 will replace the previous station on the PRESET TUNING/MESSAGE button with the station you tuned into. B --Playing the Message 1 Press PLAY/STOP. 2 Press the PRESET TUNING/ MESSAGE button, you want to listen to. You will hear a beep. Select the preset number Various Modes of CD Playback You can play tracks repeatedly or in random order. The command buttons on the remote commander are the same as the command buttons on the main unit as described below: The volume can be adjusted by pressing VOL + or - during message playback. [. . . ]